Characterisation and corrosion resistance of Zn-Mn coatings electrodeposited from acidic chloride bath

被引:4
|
作者
Rafiee, A. [1 ]
Raeissi, K. [2 ]
Golozar, M. A. [2 ]
机构
[1] Islamic Azad Univ, Najafabad Branch, Dept Mat Engn, Esfahan, Iran
[2] Isfahan Univ Technol, Dept Mat Engn, Esfahan 8415683111, Iran
来源
TRANSACTIONS OF THE INSTITUTE OF METAL FINISHING | 2014年 / 92卷 / 02期
关键词
Electrodeposition; Zn-Mn alloy; Corrosion behaviour; Morphology; Structure; PROTECTIVE ABILITY; ALLOYS; MORPHOLOGY; BEHAVIOR; TEXTURE; STEEL;
D O I
10.1179/0020296713Z.000000000122
中图分类号
O646 [电化学、电解、磁化学];
学科分类号
081704 ;
摘要
Zn-Mn alloy coatings were galvanostatically electrodeposited from an acidic chloride bath. Effects of deposition current density, pH and temperature on surface morphology, microstructure and corrosion resistance of Zn-Mn coatings were studied. The coatings deposited at 10, 50 and 100 mA cm(-2) had a single eta-Zn phase structure. However, a dual phase structure of eta-Zn and epsilon-Zn-Mn with higher Mn content was found for the coatings deposited at 200 mA cm 22. The dual structure degraded the corrosion resistance of the coatings. The highest corrosion resistance was achieved for the Zn-Mn coating deposited at 100 mA cm(-2), pH 4 center dot 9 and 25 degrees C. This coating contained 4? 1 wt-% Mn and showed a unique surface morphology consisting of randomly arranged packs of very thin platelets, laid perpendicular to the surface and provided a high compactness deficient free structure.
引用
收藏
页码:115 / 120
页数:6
相关论文
共 50 条
  • [31] Electrolytic deposition and corrosion resistance of Zn-Ni coatings obtained from sulphate-chloride bath
    Wykpis K.
    Popczyk M.
    Budniok A.
    Bulletin of Materials Science, 2011, 34 (4) : 997 - 1001
  • [32] Characterization and corrosion behavior of Co and Co-P coatings electrodeposited from chloride bath
    Ezhilselvi, V.
    Seenivasan, H.
    Bera, Parthasarathi
    Anandan, Chinnasamy
    RSC ADVANCES, 2014, 4 (86) : 46293 - 46304
  • [33] Influence of deposition temperature on the corrosion resistance of electrodeposited zinc-nickel alloy coatings
    Beheshti, M.
    Ismail, M. C.
    Kakooei, S.
    Shahrestani, S.
    Mohan, G.
    Zabihiazadboni, M.
    MATERIALWISSENSCHAFT UND WERKSTOFFTECHNIK, 2018, 49 (04) : 472 - 482
  • [34] The protective properties of epoxy coating electrodeposited on Zn-Mn alloy substrate
    Bucko, M.
    Miskovic-Stankovic, V.
    Rogan, J.
    Bajat, J. B.
    PROGRESS IN ORGANIC COATINGS, 2015, 79 : 8 - 16
  • [35] Electrodeposition of Zn and Zn-Mn alloy coatings from an electrolytic bath prepared by recovery of exhausted zinc-carbon batteries
    da Silva, Paulo Sergio
    Sartori Schmitz, Edineia P.
    Spinelli, Almir
    Garcia, Jarem Raul
    JOURNAL OF POWER SOURCES, 2012, 210 : 116 - 121
  • [36] Electrodeposited Zn-Ni-sisal Nanocrystals Composite Coatings - Morphology, Structure and Corrosion Resistance
    Borges, A. M. C.
    Koga, G. Y.
    Rigoli, I. C.
    Rocha, C. L. F.
    Santana, P. M. B.
    Sousa, C. A. C.
    MATERIALS RESEARCH-IBERO-AMERICAN JOURNAL OF MATERIALS, 2023, 26
  • [37] Corrosion resistance of multilayer coatings of nanolayered Cr/Ni electrodeposited from Cr(III)-Ni(II) bath
    Etminanfar, M. R.
    Sohi, M. Heydarzadeh
    THIN SOLID FILMS, 2012, 520 (16) : 5322 - 5327
  • [38] Influence of [BMIM]HSO4 on electrodeposition and corrosion behavior of Zn coatings from acidic sulfate bath
    Zhang, Qibo
    Hua, Yixin
    SURFACE AND INTERFACE ANALYSIS, 2012, 44 (09) : 1254 - 1260
  • [39] Pulse electrodeposition and characterization of Zn-Mn coatings deposited from additive-free chloride electrolytes
    Claudel, Florian
    Stein, Nicolas
    Allain, Nathalie
    Tidu, Albert
    Hajczak, Nicolas
    Lallement, Regis
    Close, Damien
    JOURNAL OF APPLIED ELECTROCHEMISTRY, 2019, 49 (04) : 399 - 411
  • [40] Influence of Na2TeO3 additive on electrodeposition of Zn-Mn alloy coatings from sulphate-citrate bath
    Sulcius, A.
    Griskonis, E.
    Balciunas, R.
    Diaz-Arista, P.
    TRANSACTIONS OF THE INSTITUTE OF METAL FINISHING, 2014, 92 (01): : 20 - 28