Research on the Sensitive Electric Properties of La0.9Sr0.1Ga0.8Mg0.2Ox Electrolyte

被引:0
|
作者
Gu Yuan-Yuan [1 ]
Chen Kang [1 ]
Jiang Hao [1 ]
Jian Jia-Wen [1 ]
机构
[1] Ningbo Univ, Dept Informat Sci & Engn, Ningbo 315211, Zhejiang, Peoples R China
基金
中国国家自然科学基金; 中国博士后科学基金;
关键词
LSGM; conductivity; electrolyte; oxygen sensor; OXIDE FUEL-CELL;
D O I
10.3724/SP.J.1077.2013.12281
中图分类号
TQ174 [陶瓷工业]; TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
La0.9Sr0.1Ga0.8Mg0.2Ox (LSGM) electrolytes were prepared from La0.9Sr0.1Ga0.8Mg0.2Ox powders sintering at 1000-1500 degrees C for 4 h. Both the physical and electrical properties of the LSGM samples were tested. The results show that the linear shrinkage and relative density of the samples increase with sintering temperature rising, besides, the sample sintered at 1400 degrees C for 4 h shows the maximum value of 24.8% and 97%, respectively. Samples sintered at 1250 degrees C-1500 degrees C for 4 h have uniform phase while that sintered at 1000 degrees C has a large amount of impurities. The sample sintered at 1400 degrees C for 4 h has the largest conductivity being 0.093 S/cm at 800 degrees C. Based on this, a limiting-current-type 02 sensor based on LSGM was fabricated by screen-printing technique, and the I-V characteristics and response/recovery time were measured. It shows that the I-V curves have good current plateaus, and the limiting current exhibits a linear dependence on oxygen concentration. The response/recovery time are 10-15 s and 15-20 s, respectively, showing well reproducible response characteristics.
引用
收藏
页码:409 / 414
页数:6
相关论文
共 7 条
  • [1] Solid-state amperometric CH4 sensor using, LaGaO3-based electrolyte
    Bi, Zhonghe
    Matsumoto, Hiroshige
    Ishihara, Tatsumi
    [J]. SOLID STATE IONICS, 2008, 179 (27-32) : 1641 - 1644
  • [2] A solid oxide fuel cell based on Sr- and Mg-doped LaGaO3 electrolyte:: the role of a rare-earth oxide buffer
    Huang, KQ
    Goodenough, JB
    [J]. JOURNAL OF ALLOYS AND COMPOUNDS, 2000, 303 : 454 - 464
  • [3] DOPED LAGAO3 PEROVSKITE-TYPE OXIDE AS A NEW OXIDE IONIC CONDUCTOR
    ISHIHARA, T
    MATSUDA, H
    TAKITA, Y
    [J]. JOURNAL OF THE AMERICAN CHEMICAL SOCIETY, 1994, 116 (09) : 3801 - 3803
  • [4] Materials for Solid Oxide Fuel Cells
    Jacobson, Allan J.
    [J]. CHEMISTRY OF MATERIALS, 2010, 22 (03) : 660 - 674
  • [5] Jian JW, 2004, J INORG MATER, V19, P93
  • [6] Preparation and evaluation of doped ceria interlayer on supported stabilized zirconia electrolyte SOFCs by wet ceramic processes
    Nguyen, TL
    Kobayashi, K
    Honda, T
    Iimura, Y
    Kato, K
    Neghisi, A
    Nozaki, K
    Tappero, F
    Sasaki, K
    Shirahama, H
    Ota, K
    Dokiya, M
    Kato, T
    [J]. SOLID STATE IONICS, 2004, 174 (1-4) : 163 - 174
  • [7] LSGM-based solid oxide fuel cell with 1.4 W/cm2 power density and 30 day long-term stability
    Wan, JH
    Yan, JQ
    Goodenough, JB
    [J]. JOURNAL OF THE ELECTROCHEMICAL SOCIETY, 2005, 152 (08) : A1511 - A1515