Contact forces and mechanisms in a vibratory finisher

被引：74

作者：

Yabuki, A

Baghbanan, MR

Spelt, JK

机构：

[1] Hiroshima Univ, Grad Sch Engn, Higashihiroshima 7398527, Japan

[2] Univ Toronto, Dept Mech & Ind Engn, Toronto, ON M5S 3G8, Canada

来源：

WEAR | 2002年 / 252卷 / 7-8期

基金：

加拿大自然科学与工程研究理事会;

关键词：

vibratory finishing; vibrating bed; mass finishing; contact force; friction coefficient; impact;

D O I：

10.1016/S0043-1648(02)00016-9

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

The normal and tangential contact forces in a vibratory finishing machine were measured using a newly developed force sensor. A video system was used to record the motion of the finishing media as it collided with the test surface. Media contact occurred in three different modes. The ratio of the normal and tangential forces was compared with the measured friction coefficient under dry and water-wet conditions. This confirmed that media sliding occurred under water-wet conditions. (C) 2002 Published by Elsevier Science B.V.

引用

页码：635 / 643

页数：9

共 6 条

[1]

Fraas A.P., 1996, P INT MECH ENG C EXH

[2]

GILLESPIE L, 1975, MR7511 SOC MAN ENG

[3]

Hashimoto F., 1996, CIRP ANN-MANUF TECHN, V45, P303

[4]

HIGNETT B, 1976, MR7613 SOC MAN ENG