ANALYZING THE EFFECTS OF CUTTING TOOLS GEOMETRY ON THE TURNING OF AISI 316Ti STAINLES STEEL WITH TAGUCHI METHOD

被引：0

作者：

Kayir, Yunus ^{[1
]}

Aslan, Siddik ^{[2
]}

Ayturk, Ahmet ^{[1
]}

机构：

[1] Gazi Univ, Tekn Egitim Fak, TR-06500 Ankara, Turkey

[2] Gazi Univ, Ticaret Turizm Fak, TR-06500 Ankara, Turkey

来源：

JOURNAL OF THE FACULTY OF ENGINEERING AND ARCHITECTURE OF GAZI UNIVERSITY | 2013年 / 28卷 / 02期

关键词：

Stainless steel; AISI; 316Ti; turning; coated carbide cutting tools; surface roughness; Taguchi method; ANOVA; SURFACE-ROUGHNESS; PARAMETERS; OPTIMIZATION; WEAR;

D O I：

暂无

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

In this study, A Taguchi model were designed for turning AISI 316 Ti stainless steel. Experimental works were made on the conventional machine tools. Cutting tools that were manufactured with different edge geometries and coated with TiCN-Al203-TiN were used in the experimental works. Effects of edge geometry of cutting tools and used cutting parameters on the roughness of machined surfaces were investigated. Taguchi and ANOVA analysis were carried out. Graphs that are main effects and S/N ratios of factors were done. The experimental results have shown that main effects are feed rate (73.97%) and radius of edge (13.26%) for surface roughness. It was seen that cutting tools with smaller edge radius were wearer than others.

引用

页码：363 / 371

页数：9

共 21 条

[1]

Altinkaya E., 2006, AISI 316 OST CEL ISL

[2]

Coromant S, 1997, MODERN METAL CUTTING

[3] Study of drilling metal-matrix composites based on the Taguchi techniques [J].