Modeling of autoignition and NO sensitization for the oxidation of IC engine surrogate fuels

被引:59
|
作者
Anderlohr, J. M. [1 ,2 ]
Bounaceur, R. [2 ]
Da Cruz, A. Pires [1 ]
Battin-Leclerc, F. [2 ]
机构
[1] IFP, F-92852 Rueil Malmaison, France
[2] INPL ENSIC, CNRS, Dept Chim Phys React, UMR 7630, F-54001 Nancy, France
关键词
NO sensitization; Oxidation; Autoignition; Modeling; Primary reference fuel; Toluene; Jet-stirred reactor; HCCI engine; NITRIC-OXIDE INTERACTIONS; JET-STIRRED REACTOR; HCCI COMBUSTION; SHOCK-TUBE; KINETIC-MODEL; ATMOSPHERIC CHEMISTRY; THERMAL-DECOMPOSITION; PHOTOCHEMICAL DATA; CONTROLLABLE EGR; SELF-IGNITION;
D O I
10.1016/j.combustflame.2008.09.009
中图分类号
O414.1 [热力学];
学科分类号
摘要
This paper presents an approach for modeling with one single kinetic mechanism the chemistry of the autoignition and combustion processes inside an internal combustion engine, as well as the chemical kinetics governing the postoxidation of unburned hydrocarbons in engine exhaust gases. Therefore a new kinetic model was developed, valid over a wide range of temperatures including the negative temperature coefficient regime. The model simulates the autoignition and the oxidation of engine surrogate fuels composed of n-heptane, iso-octane, and toluene, which are sensitized by the presence of nitric oxides. The new model was obtained from previously published mechanisms for the oxidation of alkanes and toluene where the coupling reactions describing interactions between hydrocarbons and NOx were added. The mechanism was validated against a wide range of experimental data obtained in jet-stirred reactors, rapid compression machines, shock tubes, and homogeneous charge compression ignition engines. Flow rate and sensitivity analysis were performed in order to explain the low temperature chemical kinetics, especially the impact of NOx on hydrocarbon oxidation. (c) 2008 The Combustion Institute. Published by Elsevier Inc. All rights reserved.
引用
收藏
页码:505 / 521
页数:17
相关论文
共 50 条
  • [11] A Review on Performance of the IC Engine Using Alternative Fuels
    Rao, Venkata Sundar K.
    Kurbet, S. N.
    Kuppast, Vinay V.
    MATERIALS TODAY-PROCEEDINGS, 2018, 5 (01) : 1989 - 1996
  • [12] Use of vegetable oils as IC engine fuels - A review
    Ramadhas, AS
    Jayaraj, S
    Muraleedharan, C
    RENEWABLE ENERGY, 2004, 29 (05) : 727 - 742
  • [13] AN APPARATUS FOR STUDYING AUTOIGNITION OF ENGINE FUELS - RESULTS WITH NORMAL HEPTANE AND NORMAL HEXANE
    LEVEDAHL, WJ
    HOWARD, FL
    JOURNAL OF RESEARCH OF THE NATIONAL BUREAU OF STANDARDS, 1951, 46 (04): : 301 - 309
  • [14] Predictions of oxidation and autoignition of large methyl ester with small molecule fuels
    Li, Ang
    Ji, Wenxia
    Huang, Zhen
    Zhu, Lei
    FUEL, 2019, 251 : 162 - 174
  • [15] Comparison of oxidation and autoignition of the two primary reference fuels by rapid compression
    Minetti, R
    Carlier, M
    Ribaucour, M
    Therssen, E
    Sochet, LR
    TWENTY-SIXTH SYMPOSIUM (INTERNATIONAL) ON COMBUSTION, VOLS 1 AND 2, 1996, : 747 - 753
  • [16] A wide-range kinetic modeling study of oxidation and combustion of transportation fuels and surrogate mixtures
    Ranzi, Eliseo
    ENERGY & FUELS, 2006, 20 (03) : 1024 - 1032
  • [17] Surrogate fuels for the simulation of diesel engine combustion of novel biofuels
    Kerschgens, Bruno
    Cai, Liming
    Pitsch, Heinz
    Janssen, Andreas
    Jakob, Markus
    Pischinger, Stefan
    INTERNATIONAL JOURNAL OF ENGINE RESEARCH, 2015, 16 (04) : 531 - 546
  • [18] Development of surrogate fuels for heavy fuel oil in marine engine
    Sun, Xiuxiu
    Liang, Xingyu
    Shu, Gequn
    Yu, Hanzhengnan
    Liu, Hai
    ENERGY, 2019, 185 : 961 - 970
  • [19] Autoignition chemistry in a motored engine: An experimental and kinetic modeling study
    Curran, HJ
    Gaffuri, P
    Pitz, WJ
    Westbrook, CK
    Leppard, WR
    TWENTY-SIXTH SYMPOSIUM (INTERNATIONAL) ON COMBUSTION, VOLS 1 AND 2, 1996, : 2669 - 2677
  • [20] OXIDATION OF DISTILLATE ENGINE FUELS BY PERMANGANATOMETRIC METHOD
    CHERTKOV, YB
    GORENKOV, AF
    CHEMISTRY AND TECHNOLOGY OF FUELS AND OILS, 1983, 19 (1-2) : 51 - 54