Hot Spot Temperature for 154 kV Transformer Filled with Mineral Oil and Natural Ester Fluid

被引：45

作者：

Kweon, Dongjin ^{[1
]}

Koo, Kyosun ^{[1
]}

Woo, Jungwook ^{[1
]}

Kim, Yungsig ^{[2
]}

机构：

[1] Korea Elect Power Res Inst, Taejon, South Korea

[2] Iljin Elect Co Ltd, Inchon, South Korea

来源：

IEEE TRANSACTIONS ON DIELECTRICS AND ELECTRICAL INSULATION | 2012年 / 19卷 / 03期

关键词：

Power transformers; Dielectric liquids; Transformer windings; Temperature measurement; Life estimation; Optical fiber sensor; POWER TRANSFORMERS; DIELECTRIC COOLANT;

D O I：

10.1109/TDEI.2012.6215107

中图分类号：

TM [电工技术]; TN [电子技术、通信技术];

学科分类号：

0808 ; 0809 ;

摘要：

This paper deals with the hot spot temperature of a transformer when filled with mineral oil, and later on, with natural ester fluid. 14 optical fiber sensors were installed in the 154 kV, 15 MVA transformer filled with mineral oil, with the hot spot temperature measured during the heat run tests. The transformer was retrofilled with natural ester fluid, after which the hot spot temperatures were measured again. For the rated power, the hottest spot temperature was 105.9 degrees C when the transformer was filled with mineral oil and 129.4 degrees C when it was filled with natural ester fluid. The hot spot temperature increased by 23.5 degrees C in the transformer filled with natural ester fluid. This paper applies the hot spot temperature measured using optical fiber sensors to the life curve in natural ester by McShane et al. The life curve of the thermally upgraded kraft paper in natural ester fluid was compared with that in mineral oil, as suggested by the IEEE guide. The life of the transformer filled with natural ester fluid was similar to that filled with mineral oil. Therefore, transformers filled with natural ester fluid do not require increase of cooling pump capacity and surface area of the radiator or reduction of the load to obtain the same life as that of the mineral oil.

引用

页码：1013 / 1020

页数：8

共 13 条

[1]

Ahuja R., 2007, 37 CIGRE

[2]

Bachinger F., 2007, CIGRE SC A2 D1 JOINT

[3]

IEC, 2011, IEC 60076-2

[4]

Martin D., 2010, AS PAC TECHCON

[5]

McShane C.P., 2006, IEEE PES TRANSM DIST

[6]

McShane CP, 2003, IEEE CEM IND TECH CO, P141, DOI 10.1109/CITCON.2003.1204715

[7] New dielectric coolant concepts for distribution and power transformers [J].

McShane, CP .

CONFERENCE RECORD OF 1999 ANNUAL PULP AND PAPER INDUSTRY TECHNICAL CONFERENCE, 1999, :55-62

[8]

McShane CP, 2006, 73 ANN INT DOBL CLIE

[9]

Mendes J. C., 2008, A2101 CIGRE

[10]

PERRIER C, 2006, IEEE T DIELECT EL IN, V13, P556

← 1 2 →