Heat-transfer from horizontal tube bundles into fluidized beds with Geldart A lignite particles

This work investigates the heat transfer mechanism in fluidized beds equipped with horizontal heat exchanger surfaces such as single tubes and especially tube bundles. Previous works were performed for varying operating conditions and solids' material properties, leading to a heterogeneous and therefore not applicable spectrum of derived correlations for the influence of tube diameter and tube bundle geometry on heat transfer. Based on a wide range validation of the correlation for the influence of single tube diameter on heat transfer coefficient, tube bundles with different tube diameters and horizontal and vertical spacings and alignments were investigated. Experiments were carried out using electrical heat transfer probes in a 0.15 m(2) fluidized bed test facility at ambient conditions. Geldart A lignite and Geldart D solids were used in order to distinguish between predominant particle-convective and gas-convective heat transfer mechanisms. The tube bundle reduction factor on heat transfer coefficient was derived as a key parameter based on dimensionless geometric numbers. This factor predicts the reduction of the heat transfer coefficient compared to that of the single tube due to the particle and gas flow disturbances caused by the immersed tubes. Tube diameter as well as tube bundle geometry were successfully implemented into useful correlations for predicting tube bundles' heat transfer of gas-solid fluidized bed systems operating with fine particles. (C) 2013 Elsevier B.V. All rights reserved.