Model inversion of satellite-measured reflectances for obtaining surface biophysical and bidirectional reflectance characteristics of grassland

An inversion method that can be used to derive information about biophysical and radiative conditions of a grassland surface from remotely sensed surface spectral reflectances is described. A previously developed simple surface bidirectional reflectance model was expanded for use in this inversion process. In the inversion process, a multidimensional optimization scheme is used to obtain a set of model parameters that minimizes the difference between modeled and observed reflectances. The effect of the slumber of data points used in the inversion on the accuracy of the model inversion was investigated with ground based hemispheric scan measurements of surface spectral reflectances over a tallgrass prairie in Kansas. The result shows that the total inversion error consists of minimum or systematic error and ambiguity error The former result from uncertainties in the accuracies of the model and measurements, whereas the latter is caused by the ambiguity of the model inversion when a limited number of data points are used The systematic error is independent of the number of data points, whereas the ambiguity error decreases sharply with increasing data points when the num ber of data points is small (fewer than about seven). An inversion method with appropriate data grouping applied to the reflectance data from the Advanced Very High Resolution Radiometer is shown to improve estimates of surface parameters over the grassland site. Relative differences between measured surface bidirectional reflectances and those calculated with the derived surface parameters range from 6% to 15% (12.9% for band 1 [0.65-0.67 mu m] 6.9% for band 2 [0.81-0.84 mu m] and 7.6% for band 3 [1.62-1.69 mu m]). (C)Elsevier Science Inc., 1997.