On grain refinement of a γ-TiAl alloy using cryo-milling followed by spark plasma sintering

被引：23

作者：

Shanmugasundaram, T. ^{[1
,2
]}

Guyon, J. ^{[1
,2
]}

Monchoux, J. P. ^{[3
]}

Hazotte, A. ^{[1
,2
]}

Bouzy, E. ^{[1
,2
]}

机构：

[1] Univ Lorraine, LEM3, CNRS, UMR 7239, F-57045 Metz 1, France

[2] Univ Lorraine, DAMAS Lab Excellence Design Alloy Met Low mAss St, F-57045 Metz 1, France

[3] Univ Toulouse, CEMES, CNRS, UPR 8011, F-31055 Toulouse 04, France

来源：

INTERMETALLICS | 2015年 / 66卷

关键词：

Titanium aluminides; Phase transformation; Cryo-milling; Spark plasma sintering; Microstructure; MECHANICAL-PROPERTIES; SIZE REFINEMENT; HIGH NB; MICROSTRUCTURE; TEMPERATURE; DEFORMATION; STRENGTH; FRACTURE; NIOBIUM; STATE;

D O I：

10.1016/j.intermet.2015.07.007

中图分类号：

O64 [物理化学（理论化学）、化学物理学];

学科分类号：

070304 ; 081704 ;

摘要：

A fully dense fine-grained gamma-TiAl based alloy was fabricated by cryo-milling pre-alloyed powders followed by spark plasma sintering. The consolidation was performed at 1050 or 1200 degrees C. The effect of cryomilling on the densification kinetics and final microstructure was studied. Results indicate that cryomilled (8 h) powder is fully densified at a temperature nearly 125 degrees C lower than that of un-milled powder. The microstructure of the alloy fabricated at different temperatures consisted of fine grains of gamma-TiAl and alpha(2) (Ti3Al) phases in different volume fractions. The average grain size of cryo-milled powders compacted at 1050 and 1200 degrees C were determined as 0.6 and 0.9 gm, respectively. It is inferred that the reduction in crystallite and particle size induced by cryo-milling is the likely reason for such enhancement in densification and grain refinement. (C) 2015 Elsevier Ltd. All rights reserved.

引用

页码：141 / 148

页数：8

共 51 条

[51] Formation of nanostructure in Al produced by a low-energy ball milling at cryogenic temperature [J].

Zhou, F ;

Witkin, D ;

Nutt, SR ;

Lavernia, EJ .

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2004, 375 (1-2 SPEC. ISS.) :917-921

← 1 2 3 4 5 6 →