Finite element modeling of plasticity-induced crack closure due to occasional mode II loading on mode I fatigue crack growth

被引：6
|
作者：
Matsunaga, H. [1 ,2 ,3 ]
Makizaki, M. [4 ]
Yanase, K. [3 ,4 ]
机构：
[1] Kyushu Univ, Dept Mech Engn, Nishi Ku, Fukuoka 8190395, Japan
[2] Kyushu Univ, Int Inst Carbon Neutral Energy Res I2CNER, Nishi Ku, Fukuoka 8190395, Japan
[3] Fukuoka Univ, Inst Mat Sci & Technol, Jonan Ku, Fukuoka 8140180, Japan
[4] Fukuoka Univ, Dept Mech Engn, Jonan Ku, Fukuoka 8140180, Japan
来源：
ENGINEERING FRACTURE MECHANICS | 2013年 / 111卷
关键词：
Crack closure; Finite element analysis; Fatigue crack growth; Occasional shear loading; CTOD; PLANE-STRAIN; REDUCTION; GEOMETRY; STRESS;
D O I：
10.1016/j.engfracmech.2013.09.001
中图分类号：
O3 [力学];
学科分类号：
08 ; 0801 ;
摘要：
Plasticity-induced fatigue crack closure associated with occasional mode II loading was simulated for two-dimensional middle-crack tension geometry by using the finite element method. When a single mode II cycle was superposed onto the steady-state mode I crack growth, the range of crack tip opening displacement, Delta CTOD, exhibited the initial drop and subsequent recovery under plane strain condition. On the other hand, under plane stress condition, Delta CTOD exhibited the initial jump and drop right after the single mode II loading, and then it showed the recovery. The present results indicate that occasional mode II loading can cause a small retardation for mode I crack growth due to the enhanced plasticity-induced closure. (C) 2013 Elsevier Ltd. All rights reserved.
引用
收藏
页码：38 / 49
页数：12
相关论文
共 50 条
  • [31] On the accurate assessment of crack opening and closing stresses in plasticity-induced fatigue crack closure problems
    de Matos, P. F. P.
    Nowell, D.
    ENGINEERING FRACTURE MECHANICS, 2007, 74 (10) : 1579 - 1601
  • [32] Some issues on finite element modelling of plasticity induced crack closure due to constant amplitude loading
    Singh, Konjengbam Darunkumar
    Parry, Matthew Roger
    Sinclair, Ian
    INTERNATIONAL JOURNAL OF FATIGUE, 2008, 30 (10-11) : 1898 - 1920
  • [33] On crack tip shielding due to plasticity-induced closure during an overload
    Colombo, C.
    Du, Y.
    James, M. N.
    Patterson, E. A.
    Vergani, L.
    FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES, 2010, 33 (12) : 766 - 777
  • [34] Effects of Localized Plasticity-Induced Transformation on Fatigue Crack Growth
    K. Sadananda
    N. Iyyer
    M. Nani Babu
    Transactions of the Indian National Academy of Engineering, 2022, 7 (2) : 385 - 395
  • [35] Sustained mode I and mode II fatigue crack growth in flat plates
    Magill, MA
    Zwerneman, FJ
    ENGINEERING FRACTURE MECHANICS, 1996, 55 (06) : 883 - &
  • [36] The influence of plasticity-induced crack closure on creep-fatigue crack growth in two heat-resistant steels
    Ramirez, J.
    Potirniche, G. P.
    Shaber, N.
    Taylor, M.
    Pugesek, H.
    Stephens, R.
    Charit, I.
    INTERNATIONAL JOURNAL OF FATIGUE, 2019, 125 : 291 - 298
  • [37] Modeling of fatigue crack closure by finite element method
    Ding, Zhenyu
    Wang, Xiaogui
    Gao, Zengliang
    ADVANCES IN PRODUCT DEVELOPMENT AND RELIABILITY III, 2012, 544 : 145 - +
  • [38] Numerical Modeling of Plasticity-Induced Fatigue Crack Growth Retardation Due to Deflection in the Near-Tip Area
    Toribio, Jesus
    Matos, Juan-Carlos
    Gonzalez, Beatriz
    METALS, 2021, 11 (04)
  • [39] A displacement-based method for predicting plasticity-induced fatigue crack closure
    Pawlik, ME
    Saff, CR
    ADVANCES IN FATIGUE CRACK CLOSURE MEASUREMENT AND ANALYSIS: VOL 2, 1999, 1343 : 427 - 439
  • [40] FINITE-ELEMENT ANALYSIS OF PLASTICITY-INDUCED CRACK CLOSURE UNDER PLANE-STRAIN CONDITIONS
    FLECK, NA
    ENGINEERING FRACTURE MECHANICS, 1986, 25 (04) : 441 - 449
12345