Pre-eruptive conditions of dacitic magma erupted during the 21.7 ka Plinian event at Nevado de Toluca volcano, Central Mexico

The Nevado de Toluca volcano in Central Mexico has been active over the last ca. 42 ka, during which tens of km(3) of pyroclastic material were erupted and two important Plinian-type eruptions occurred at ca. 21.7 ka (Lower Toluca Pumice: LTP) and ca. 10.5 ka (Upper Toluca Pumice: UTP). Samples from both the LTP and UTP contain plagioclase, amphibole, iron-titanium oxides, and minor anhedral biotite, set in a vesicular, rhyolitic, glassy matrix. In addition, UTP dacites contain orthopyroxene. Analysis of melt inclusions in plagioclase phenocrysts yields H2O contents of 2-3.5 wt.% for LTP and 13-3.6 wt.% for UTP samples. Ilmenite-ulvospinel geothermometry yields an average temperature of similar to 868 degrees C for the LTP magma (hotter than the UTP magma, similar to 842 degrees C; Arce et al., 2006), whereas amphibole-plagioclase geothermometry yields a temperature of 825-859 degrees C for the LTP magma. Water-saturated experiments using LTP dacite suggest that: (i) amphibole is stable above 100 MPa and below 900 degrees C; (ii) plagioclase crystallizes below 250-100 MPa at temperatures of 850-900 degrees C; and (iii) pyroxene is stable only below pressures of 200-100 MPa and temperatures of 825-900 degrees C. Comparison of natural and experimental data suggests that the LTP dacitic magma was stored at 150-200 MPa (5.8-7.7 km below the volcano summit). No differences in pressure found between 21.7 ka and 10.5 ka suggest that these two magmas were stored at similar depths. Orthopyroxene produced in lower temperature LTP experiments is compositionally different to those found in UTP natural samples, suggesting that they originated in two different magma batches. Whole-rock chemistry, petrographic features, and mineral compositions suggest that magma mixing was responsible for the generation of the dacitic Plinian LTP eruption. (C) 2012 Elsevier B.V. All rights reserved.