Measurement of effective hydrogen diffusivity using the Scanning Kelvin Probe

被引：50

作者：

Schaller, R. F. ^{[1
]}

Scully, J. R. ^{[1
]}

机构：

[1] Univ Virginia, Dept Mat Sci & Engn, Charlottesville, VA 22904 USA

来源：

ELECTROCHEMISTRY COMMUNICATIONS | 2014年 / 40卷

关键词：

Scanning Kelvin Probe; Effective hydrogen diffusivity; FORCE MICROSCOPY; IRON; PERMEATION; DEUTERIUM; STEEL; TOOL; GAS;

D O I：

10.1016/j.elecom.2013.12.025

中图分类号：

O646 [电化学、电解、磁化学];

学科分类号：

081704 ;

摘要：

Effective hydrogen diffusivity (D-H,D-eff) was determined utilizing the Scanning Kelvin Probe (SKP) to measure the SKP voltage on cross-sectioned, hydrogen pre-charged samples at 25 degrees C. Two secondary hardened martensitic steels, Fe-13Co-11Ni-3Cr-1.2Mo-0.2C-0.02Mn and Fe-11Ni-12Cr-lMo-0.005C-0.02Mn (wt%) were evaluated. D-H,D-eff was 1.5 to 2 x 10(-8) cm(2)/s. Results compared well to previously reported measurements for Fe-13Co-11Ni-3Cr-1.2Mo-0.2C-0.02Mn steel using isothermal Thermal Desorption (TDS) and an Arrhenius relationship to obtain an average D-H,D-eff of 8.96 x 10(-9) cm(2)/s at 25 degrees C (Thomas etal., 2002). (C) 2013 Elsevier By. All rights reserved.

引用

页码：42 / 44

页数：3

共 50 条

[41] Enrichment of Alloying Elements in Aluminum: A Scanning Kelvin Probe Approach [J].

Garcia-Vergara, S. J. ;

Skeldon, P. ;

Thompson, G. E. ;

Williams, G. ;

McMurray, H. N. .

JOURNAL OF THE ELECTROCHEMICAL SOCIETY, 2012, 159 (09) :C428-C433

[42] Challenges in hydrogen quantification using Kelvin probe technique at different levels of relative humidity [J].

Wolfgang Burgstaller ;

Gabriela Schimo ;

Achim Walter Hassel .

Journal of Solid State Electrochemistry, 2017, 21 :1785-1796

[43] Quantitative calibration of the relationship between Volta potential measured by scanning Kelvin probe force microscope (SKPFM) and hydrogen concentration [J].

Ma, Zhaoxiang ;

Xiong, Xilin ;

Chen, Lin ;

Su, Yanjing .

ELECTROCHIMICA ACTA, 2021, 366

[44] Characterization of corrosion of X70 pipeline steel in thin electrolyte layer under disbonded coating by scanning Kelvin probe [J].

Fu, A. Q. ;

Tang, X. ;

Cheng, Y. F. .

CORROSION SCIENCE, 2009, 51 (01) :186-190

[45] Hydrogen distribution and segregation in hydrogen-charged S30408 after fracture analyzed via scanning Kelvin probe force microscopy [J].

Shang, Juan ;

Hua, Zhengli .

APPLIED SURFACE SCIENCE, 2020, 528

[46] Localized corrosion of heat-treated and welded stainless steel studied using a scanning Kelvin probe [J].

Bäck, G ;

Nazarov, A ;

Thierry, D .

CORROSION, 2005, 61 (10) :951-960

[47] Beyond the blur: Using experimentally determined point spread functions to improve scanning Kelvin probe imaging [J].

Lenton, Isaac C. D. ;

Pertl, Felix ;

Shafeek, Lubuna ;

Waitukaitis, Scott R. .

JOURNAL OF APPLIED PHYSICS, 2024, 136 (04)

[48] Scanning Kelvin probe study of steel/oil interfaces for corrosion evaluation [J].

Singh, Arun Kumar ;

Rani, Nitu .

MATERIALS AND CORROSION-WERKSTOFFE UND KORROSION, 2019, 70 (07) :1162-1170

[49] Degradation of organic coatings in a corrosive environment: a study by scanning Kelvin probe and scanning acoustic microscope [J].

Reddy, B ;

Sykes, JM .

PROGRESS IN ORGANIC COATINGS, 2005, 52 (04) :280-287

[50] Breakdown of organic coatings in corrosive environments examined by scanning Kelvin probe and scanning acoustic microscopy [J].

Reddy, B ;

Doherty, M ;

Sykes, JM .

ELECTROCHIMICA ACTA, 2004, 49 (17-18) :2965-2972

← 1 2 3 4 5 →