A comparison of rapid prototyping techniques used for wind tunnel model fabrication

被引：51

作者：

Chuk, Raymond N. ^{[1
]}

Thomson, Vincent J. ^{[1
]}

机构：

[1] McGill Univ, Dept Mech Engn, Quebec City, PQ, Canada

来源：

RAPID PROTOTYPING JOURNAL | 1998年 / 4卷 / 04期

关键词：

D O I：

10.1108/13552549810239030

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

For faster new product introduction aerospace companies are interested in reducing the time it takes to make wind tunnel models. The increased capabilities of rapid prototyping technologies has made them attractive for this purpose. A study was done of rapid prototyping technologies and their ability to make components for wind tunnel models in a timely and cost effective manner. Components and corresponding fabrication technologies were put into three categories: non-structurally loaded, lightly loaded and highly loaded according to the stress endured during wind tunnel tests, Rapid prototyping technologies were found capable for non-structurally loaded parts, but numerically controlled machining was still best for any part enduring significant loads.

引用

页码：185 / 196

页数：12