A Low-Cost Platform for Voice Monitoring

被引:0
作者
Carullo, A. [1 ]
Vallan, A. [1 ]
Astolfi, A.
机构
[1] Politecn Torino, Dipartimento Elettron & Telecomunicaz, I-10129 Turin, Italy
来源
2013 IEEE INTERNATIONAL INSTRUMENTATION AND MEASUREMENT TECHNOLOGY CONFERENCE (I2MTC) | 2013年
关键词
VIBRATION; FATIGUE;
D O I
暂无
中图分类号
TH7 [仪器、仪表];
学科分类号
0804 ; 080401 ; 081102 ;
摘要
A low-cost platform is proposed in this paper that has been conceived to monitor the vocal activity of people that use the voice as a professional tool. Such a platform includes a wearable data-logger and a processing program that allows the vocal parameters to be extracted from the recorded signal. The data-logger is equipped with a contact microphone that is attached to the jugular notch of the person under monitoring, thus sensing the skin acceleration level due to the vibration of the vocal folds. The microphone output is conditioned through a custom circuitry and then sent to a cheap micro-controller-based board, which stores the raw samples onto a micro SD-card. The off-line processing provides an estimation of Sound Pressure Level (SPL), fundamental frequency (F-0) and Time Dose (D-t), which are the parameters that seem most suitable for the identification of vocal disorders and the prevention of an improper use of the voice. For the estimated parameters, suitable calibration procedures are implemented and their effectiveness is shown through specifically conceived experimental tests. Experimental results are shown that refer to the calibration of the device and its normal use during monitoring interval of several hours. A comparison with a commercial device is also reported.
引用
收藏
页码:67 / 72
页数:6
相关论文
共 50 条
  • [41] Tool Life Monitoring in End Milling of AISI H13 Hot Work Die Steel Using a Low-Cost Vibration Sensor Connected to a Wireless System
    Vianello, P. I. A.
    Abrao, A. M.
    Maia, A. A. T.
    Pereira, I. C.
    EXPERIMENTAL TECHNIQUES, 2023, 47 (06) : 1149 - 1159
  • [42] Tool Life Monitoring in End Milling of AISI H13 Hot Work Die Steel Using a Low-Cost Vibration Sensor Connected to a Wireless System
    P.I.A. Vianello
    A.M. Abrão
    A.A.T. Maia
    I.C. Pereira
    Experimental Techniques, 2023, 47 : 1149 - 1159
  • [43] Excitation Shifting: A General Low-Cost Solution for Eliminating Ultra-Low-Frequency Torque Ripple in Switched Reluctance Machines
    Nasirian, Vahidreza
    Davoudi, Ali
    Kaboli, Shahriyar
    Edrington, Chris S.
    IEEE TRANSACTIONS ON MAGNETICS, 2013, 49 (09) : 5135 - 5149
  • [44] A High-Efficiency Low-Cost Multi-Antenna Energy Harvesting System With Leakage Suppression
    Zhang, Zhaobo
    Zhan, Chenchang
    Zhao, Shuangxing
    Law, Man-Kay
    IEEE JOURNAL OF SOLID-STATE CIRCUITS, 2024, 59 (09) : 2995 - 3007
  • [45] A low-cost, open-source centrifuge adaptor for separating large volume clinical blood samples
    Haque, Md Ehtashamul
    Marriott, Linda
    Naeem, Noman
    Henry, Taygan
    Conde, Alvaro J.
    Kersaudy-Kerhoas, Maiwenn
    PLOS ONE, 2022, 17 (07):
  • [46] A low-cost and portable wrist exoskeleton using EEG-sEMG combined strategy for prolonged active rehabilitation
    Yang, Shiqi
    Li, Min
    Wang, Jiale
    Shi, Zhilei
    He, Bo
    Xie, Jun
    Xu, Guanghua
    FRONTIERS IN NEUROROBOTICS, 2023, 17
  • [47] Detection of Physical Strain and Fatigue in Industrial Environments Using Visual and Non-Visual Low-Cost Sensors
    Papoutsakis, Konstantinos
    Papadopoulos, George
    Maniadakis, Michail
    Papadopoulos, Thodoris
    Lourakis, Manolis
    Pateraki, Maria
    Varlamis, Iraklis
    TECHNOLOGIES, 2022, 10 (02)
  • [48] A Novel, Open-Source, Low-Cost Bioreactor for Load-Controlled Cyclic Loading of Tendon Explants
    Pedaprolu, Krishna
    Szczesny, Spencer E.
    JOURNAL OF BIOMECHANICAL ENGINEERING-TRANSACTIONS OF THE ASME, 2022, 144 (08):
  • [49] Ultra low power wireless multi-sensor platform dedicated to machine tool condition monitoring
    Caroff, Tristan
    Brulais, Sebastien
    Faucon, Adrien
    Boness, Axel
    Arrizabalaga, Anne Sanz
    Ellinger, Johannes
    30TH INTERNATIONAL CONFERENCE ON FLEXIBLE AUTOMATION AND INTELLIGENT MANUFACTURING (FAIM2021), 2020, 51 : 296 - 301
  • [50] A Data-Fusion Approach for Speed Estimation and Location Calibration of a Metro Train Based on Low-Cost Sensors in Smartphones
    Wang, Yuan
    Cong, Jianli
    Wang, Ping
    Liu, Xiang
    Tang, Huiyue
    IEEE SENSORS JOURNAL, 2019, 19 (22) : 10744 - 10752