Analysis and Modelling of Common-Mode Oscillations of Electrical Drive Systems with Active Front End and Long Motor Cables

被引:0
|
作者
Weidinger, T. [1 ]
Piepenbreier, B. [1 ]
机构
[1] Univ Erlangen Nurnberg, Chair Elect Drives, D-91058 Erlangen, Germany
关键词
common-mode noise; EMC; EMI; modelling;
D O I
10.1109/SPEEDHAM.2008.4581103
中图分类号
TE [石油、天然气工业]; TK [能源与动力工程];
学科分类号
0807 ; 0820 ;
摘要
This paper presents an analysis of common-mode oscillations in electrical drive systems. The analysed oscillations occur particularly in electrical drive systems with active front end, common DC-link and long shielded motor cables. Because of resonant frequencies at 10 to 40 kHz low damping occurs. In the concerned frequency range switching operations generate a significant excitation. As the focus of this paper the common mode system of an electrical drive system is analysed and modelled. The damping behaviour of the choke and the switching of active front end and inverters have to be analysed very carefully. Simulations and measurements show apparent voltage stressing of motors, common mode losses and currents that disturb the drive system.
引用
收藏
页码:906 / 911
页数:6
相关论文
共 50 条
  • [41] A novel inverter-output passive filter for reducing both differential- and common-mode dv/dt at the motor terminals in PWM drive systems
    Chen, Xiyou
    Xu, Dianguo
    Liu, Fengchun
    Zhang, Jianqiu
    IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS, 2007, 54 (01) : 419 - 426
  • [42] Parameter identification of simplified common-mode equivalent circuit for inverter-fed motor drive systems by applying computer-aided optimization software
    Tang, Yizhanyi
    Ogasawara, Satoshi
    Takemoto, Masatsugu
    Tokiwa, Tsuyoshi
    Kanamori, Masaki
    IEEJ Transactions on Electrical and Electronic Engineering, 2016, 11 (02): : 243 - 249
  • [43] Reduction of Common-Mode Conducted Noise Emissions in PWM Inverter-fed AC Motor Drive Systems using Optimized Passive EMI Filter
    Jettanasen, C.
    Ngaopitakkul, A.
    IAENG TRANSACTIONS ON ENGINEERING TECHNOLOGIES, VOL 5, 2010, 1285 : 450 - 460
  • [44] Enhanced direct torque control and predictive torque control strategies of an open-End winding induction motor drive to eliminate common-mode voltage and weighting factors
    Kumar, Kunisetti V. Praveen
    Kumar, Thippiripati Vinay
    IET POWER ELECTRONICS, 2019, 12 (08) : 1986 - 1997
  • [45] Comparative Analysis of Two-Phase and Three-Phase Common-Mode Equivalent Circuit for Three-Phase Brushless DC Motor Drive
    Singh, Samarjeet
    Gorla, Naga Brahmendra Yadav
    Kalaiselvi, Dr. J.
    2022 IEEE INTERNATIONAL CONFERENCE ON POWER ELECTRONICS, DRIVES AND ENERGY SYSTEMS, PEDES, 2022,
  • [46] A Reduced Switching PWM Technique with Common-Mode Voltage Elimination for Single DC Source Fed Five-Phase Open-End Winding Induction Motor Drive
    Belkhode, Satish
    Jain, Sachin
    IECON 2017 - 43RD ANNUAL CONFERENCE OF THE IEEE INDUSTRIAL ELECTRONICS SOCIETY, 2017, : 681 - 686
  • [47] A Stacked Multilevel Inverter With Single DC Link for Open-End Winding Induction Motor Drive With Zero-Voltage Switching and Common-Mode Vol age Elimination
    Nadh, Greeshma
    Rahul, Arun S.
    IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS, 2022, 69 (12) : 12316 - 12325
  • [48] Circuit Modeling and Statistical Analysis of Differential-to-Common-Mode Noise Conversion Due to Filter Unbalancing in Three-Phase Motor Drive Systems
    Bellan, Diego
    ELECTRONICS, 2020, 9 (10) : 1 - 19
  • [49] Analysis of Dead Time Influence on Common Mode Volt-Second and Inductor Saturation in Three-Phase DC-Fed Motor Drive Systems
    Zhang, Xuning
    Boroyevich, Dushan
    Burgos, Rolando
    2015 THIRTIETH ANNUAL IEEE APPLIED POWER ELECTRONICS CONFERENCE AND EXPOSITION (APEC 2015), 2015, : 1177 - 1184
  • [50] Simulation and Analysis of Common Mode Voltage, Bearing Voltage and Bearing Current in Two-Level and Three-Level PWM Inverter Fed Induction Motor Drive with Long Cable
    Reddy, Sharana
    Basavaraja, B.
    PROCEEDINGS OF THE 2015 INTERNATIONAL CONFERENCE ON POWER AND ADVANCED CONTROL ENGINEERING (ICPACE), 2015, : 221 - 226