Numerical simulation of the resin transfer mold filling process using the boundary element method

A numerical simulation of the mold filling process during resin transfer molding with a heated die was performed using the boundary element method. The governing differential equation with a variable coefficient was rearranged into a system of Poisson equations using the perturbation technique. The boundary element method was employed to solve the resulting equations. The resin viscosity was calculated by introducing markers at the resin inlet and tracing them. As the calculation domain changes because of the proceeding resin front, numerical calculation nodes on the boundary were rearranged for each time step and integration was performed only for the meshes in the calculation domain among the fixed meshes over the mold. Sample calculations were performed for two molds with different shapes. To check the validity of the numerical scheme, the calculated mass flow rate at the resin front was compared with the mass nux at the inlet. Close agreement was observed.