Modeling and experimental study on the performance of an inverter air conditioner using R-410A with evaporatively cooled condenser

被引:41
作者
Sarntichartsak, Pongsakorn [1 ]
Thepa, Sirichai [2 ]
机构
[1] Prince Songkla Univ, Fac Sci & Ind Technol, Muang 84100, Surat Thani, Thailand
[2] King Mongkuts Univ Technol Thonburi, Sch Energy & Mat, Bangkok 10140, Thailand
关键词
Alternative refrigerant; Evaporative cooling; Modeling; Optimal charge; Variable capacity system; TUBE HEAT-EXCHANGERS; ARTIFICIAL NEURAL-NETWORK; MASS-TRANSFER; DEHUMIDIFYING CONDITIONS; SIDE PERFORMANCE; SINGLE-PHASE; REFRIGERATION SYSTEM; CAPILLARY-TUBE; PRESSURE-DROP; FINNED TUBE;
D O I
10.1016/j.applthermaleng.2012.08.063
中图分类号
O414.1 [热力学];
学科分类号
摘要
The better improvement on the system performance of R-410A inverter air conditioner was performed. The proper operating strategies of whole system with evaporatively cooling unit were investigated experimentally and numerically. The adapting system was tested by varying of frequency, water flow rate and spraying temperature. Fortunately, the combined system obtained an extended frequency range of 30-90 Hz properly. A longer capillary tube length of 887 mm with a lower optimal charge of 1.1 kg was chosen for the water temperature closed to inlet wet-bulb temperature. The water injection rate of 200 l/h obtains the best COP at a low frequency range while the flow rate of 100 l/h being at a high frequency range. Finally, the integrated model and the leakage inventory model were developed to predict the performance and the optimal charge, respectively. It can be concluded that the proposed models give a satisfactory agreement with test data. (c) 2012 Elsevier Ltd. All rights reserved.
引用
收藏
页码:597 / 610
页数:14
相关论文
共 46 条
[1]   Application of neural network for the modeling and control of evaporative condenser cooling load [J].
Abbassi, A ;
Bahar, L .
APPLIED THERMAL ENGINEERING, 2005, 25 (17-18) :3176-3186
[2]   Numerical modeling of rigid media evaporative cooler [J].
Beshkani, A ;
Hosseini, R .
APPLIED THERMAL ENGINEERING, 2006, 26 (5-6) :636-643
[3]   Measurements and correlations of frictional single-phase and two-phase pressure drops of R-410A flow in small U-type return bends [J].
Chen, IY ;
Wang, CC ;
Lin, SY .
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2004, 47 (10-11) :2241-2249
[4]   An empirical correlation for two-phase frictional performance in small diameter tubes [J].
Chen, IY ;
Yang, KS ;
Wang, CC .
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2002, 45 (17) :3667-3671
[5]  
Chung M., 1998, ASHRAE T, V104, P1031
[6]   Experiments with micro-fin tube in single phase [J].
Copetti, JB ;
Macagnan, MH ;
de Souza, D ;
Oliveski, RDC .
INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2004, 27 (08) :876-883
[7]   Performance analysis of two-stage evaporative coolers [J].
El-Dessouky, H ;
Ettouney, H ;
Al-Zeefari, A .
CHEMICAL ENGINEERING JOURNAL, 2004, 102 (03) :255-266
[8]   Comparative analysis of an evaporative condenser using artificial neural network and adaptive neuro-fuzzy inference system [J].
Ertunc, H. Metin ;
Hosoz, Murat .
INTERNATIONAL JOURNAL OF REFRIGERATION, 2008, 31 (08) :1426-1436
[9]   Artificial neural network analysis of a refrigeration system with an evaporative condenser [J].
Ertunc, HM ;
Hosoz, M .
APPLIED THERMAL ENGINEERING, 2006, 26 (5-6) :627-635
[10]   Condensation and evaporation heat transfer of R410A inside internally grooved horizontal tubes [J].
Goto, M ;
Inoue, N ;
Ishiwatari, N .
INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2001, 24 (07) :628-638