Temperature effect on dynamic compression performance of random fibrous composites in the TTT and IP directions

被引:2
|
作者
Li, Datao [1 ,2 ]
Jiang, Jinsong [2 ]
Zhang, Chao [3 ]
Yu, Wenshan [3 ]
Lu, Pengmin [1 ]
Shen, Shengping [3 ]
机构
[1] Changan Univ, MOE, Key Lab Rd Construct Technol & Equipment, Xian 710064, Peoples R China
[2] Chengdu Aircraft Design & Res Inst, Strength Design & Res Dept, Chengdu 610041, Peoples R China
[3] Xi An Jiao Tong Univ, Sch Aerosp, State Key Lab Strength & Vibrat Mech Struct, Shaanxi Engn Lab Vibrat Control Aerosp Struct, Xian 710049, Peoples R China
基金
中国国家自然科学基金;
关键词
Random fibrous (RF) composites; High strain rate (HSR); High-temperature; Strain-rate sensitivity (SRS) coefficient; Fracture mode; MECHANICAL-PROPERTIES; STRAIN-RATE; C/SIC COMPOSITES; TENSILE BEHAVIOR; WOVEN COMPOSITES; FRACTURE; IMPACT; GLASS; ENERGY; MODEL;
D O I
10.1016/j.jeurceramsoc.2022.01.028
中图分类号
TQ174 [陶瓷工业]; TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
This study examines the effect of temperature on the dynamic compressive performance of random fibrous (RF) composites at temperatures up to 1273 K in the through-the-thickness (TTT) and the in-plane (IP) directions, using an improved high-temperature split Hopkinson pressure bar (SHPB) system. The results revealed that in the IP direction, the RF composite presented a shear fracture mode below 1073 K and initiated multiple major cracks in the specimens at 1273 K. However, the composite showed a layered fracture mode in the TTT direction from 288 to 1273 K. The dynamic strength in both directions showed a consistent trend when observed under static loading below the critical temperature. The change in the strain-rate sensitivity (SRS) of the dynamic strength was insignificant for temperatures below the transition temperature of viscous-flow and brittle deformation of the RF composite. However, above the transition temperature, the SRS of the dynamic strength became significant.
引用
收藏
页码:2400 / 2407
页数:8
相关论文
共 42 条
  • [31] Effect of saturation-temperature on the performance of a vapour-compression refrigeration-cycle working on different refrigerants using exergy method
    Kopac, Mehmet
    Zemher, Bilal
    INTERNATIONAL JOURNAL OF ENERGY RESEARCH, 2006, 30 (09) : 729 - 740
  • [32] Performance of natural-fiber-plastic composites under stress for outdoor applications: Effect of moisture, temperature, and ultraviolet light exposure
    Lopez, JL
    Sain, M
    Cooper, P
    JOURNAL OF APPLIED POLYMER SCIENCE, 2006, 99 (05) : 2570 - 2577
  • [33] A parametric simulation on the effect of the rejected brine temperature on the performance of multieffect distillation with thermal vapour compression desalination process and its environmental impacts
    Buabbas, Saleh K.
    Al-Obaidi, Mudhar A.
    Mujtaba, Iqbal M.
    ASIA-PACIFIC JOURNAL OF CHEMICAL ENGINEERING, 2020, 15 (06)
  • [34] Experimental investigation on strain rate effect of high-performance fiber reinforced cementitious composites subject to dynamic direct tensile loading
    Li, Qinghua
    Jiang, Xiao
    Zeng, Tian
    Xu, Shilang
    CEMENT AND CONCRETE RESEARCH, 2022, 157
  • [35] Pyrolyzed biomass from corn ethanol industry coproduct and their polypropylene-based composites: Effect of heat treatment temperature on performance of the biocomposites
    Paleri, Drupitha M.
    Rodriguez-Uribe, Arturo
    Misra, Manjusri
    Mohanty, Amar Kumar
    COMPOSITES PART B-ENGINEERING, 2021, 215
  • [36] Integrated Effect of Flow Field Misalignment and Gas Diffusion Layer Compression/Intrusion on High Temperature - Polymer Electrolyte Membrane Fuel Cell Performance
    Babu, K. P. Venkatesh
    Varghese, Geethu
    Joseph, Thadathil Varghese
    Chippar, Purushothama
    JOURNAL OF THE ELECTROCHEMICAL SOCIETY, 2022, 169 (12)
  • [37] Strain rate and temperature effect on mechanical properties and failure of 3D needle-punched Carbon/Carbon composites under dynamic loading
    Li, Dian-sen
    Duan, Hong-Wei
    Wang, Wei
    Ge, Dong-yun
    Jiang, Lei
    Yao, Qian-qian
    COMPOSITE STRUCTURES, 2017, 172 : 229 - 241
  • [38] Effect of sintering temperature and Y2O3 content on the comprehensive performance of Sialon-TiB2-AlN-cBN composites
    Zhong, Shenglin
    Wu, Yi
    Hu, Xixi
    INTERNATIONAL JOURNAL OF APPLIED CERAMIC TECHNOLOGY, 2025,
  • [39] Effect of Fluoride Content on Friction and Wear Performance of Ni3Al Matrix High-Temperature Self-Lubricating Composites
    Zhu, Shengyu
    Bi, Qinling
    Yang, Jun
    Liu, Weimin
    TRIBOLOGY LETTERS, 2011, 43 (03) : 341 - 349
  • [40] Effect of Fluoride Content on Friction and Wear Performance of Ni3Al Matrix High-Temperature Self-Lubricating Composites
    Shengyu Zhu
    Qinling Bi
    Jun Yang
    Weimin Liu
    Tribology Letters, 2011, 43 : 341 - 349