A finite-strain elastoplasticity material model for ETFE membrane structures

被引：8

作者：

Coelho, Marianna ^{[1
]}

Roehl, Deane ^{[2
,3
]}

机构：

[1] Univ Estado Santa Catarina, Dept Engn Civil, Rua Paulo Malschitzki, BR-89219710 Joinville, SC, Brazil

[2] Pontificia Univ Catolica Rio de Janeiro, Inst Tecgraf, Rio De Janeiro, RJ, Brazil

[3] Pontificia Univ Catolica Rio de Janeiro, Dept Engn Civil, Rio De Janeiro, RJ, Brazil

来源：

COMPUTERS & STRUCTURES | 2019年 / 217卷

关键词：

Inflated membranes; Membrane materials; Finite-element method; ETFE; LOGARITHMIC STRAIN; STRESS;

D O I：

10.1016/j.compstruc.2019.03.007

中图分类号：

TP39 [计算机的应用];

学科分类号：

081203 ; 0835 ;

摘要：

This work presents a numerical model for the simulation of the behavior of membrane structures fabricated using ethylene tetrafluoroethylene (ETFE) materials. The elastoplastic material model with von Mises yield criteria is considered in the numerical analysis. Small strain and large strain formulation were adopted for comparison. The model simulates material tests, uniaxial and biaxial, and a burst test, for which experimental measurements are available. The use of von Mises yield criteria is suggested for ETFE foils. The results obtained with the numerical analysis with large strains are in accordance with the experimental results. On the other hand, the results of the numerical analysis with small strains are valid only in the first few steps of the analysis. These results reinforce the importance of considering a material model with large strains to model this type of material. (C) 2019 Elsevier Ltd. All rights reserved.

引用

页码：36 / 44

页数：9

共 29 条

[1] Modeling large strain anisotropic elasto-plasticity with logarithmic strain and stress measures [J].