Waste granite powders as fillers in epoxy coatings: A case study in a car repair workshop

被引：2

作者：

Chowaniec-Michalak, Agnieszka ^{[1
]}

Czarnecki, Slawomir ^{[1
]}

Sadowski, Lukasz ^{[1
]}

机构：

[1] Wroclaw Univ Sci & Technol, Dept Mat Engn & Construct Proc, Wybrzeze Wyspianskiego 27, PL-50370 Wroclaw, Poland

来源：

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE | 2024年 / 238卷 / 07期

关键词：

Industrial floor; epoxy resin coating; adhesion; pull-off strength; concrete substrate; COMPOSITES;

D O I：

10.1177/09544062221126639

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

Epoxy coatings of floors are a very good solution for car repair workshops. Epoxy coatings provide the floor with resistance to oil, fuel, and grease staining. The floor surface is very easy to clean. To support sustainable development, a filler in the form of waste granite powder was added to the epoxy coating. In a car repair workshop, an epoxy coating of the floor was made according to the recipe previously developed in laboratory tests. The pull-off strength of the concrete substrate was tested before and after the mechanical treatment of concrete surface. The pull-off strength of the epoxy coating was also tested. The obtained results were compared with the laboratory results. It has been proved that the waste granite filler does not deteriorate the pull-off strength of the epoxy coating and thus its durability. The waste granite powder can be successfully applied as a filler in real epoxy coatings of floors.

引用

页码：2583 / 2591

页数：9

共 28 条

[1] Preparation of photoluminescent and anticorrosive epoxy paints immobilized with nanoscale graphene from sugarcane bagasse agricultural waste [J].

Al-nami, Samar Y. ;

Al-Qahtani, Salhah D. ;

Snari, Razan M. ;

Ibarhiam, Saham F. ;

Alfi, Alia Abdulaziz ;

Aldawsari, Afrah M. ;

El-Metwaly, Nashwa M. .

ENVIRONMENTAL SCIENCE AND POLLUTION RESEARCH, 2022, 29 (40) :60173-60188

[2]

[Anonymous], 2009, D454117 ASTM, DOI DOI 10.1520/D4541-17

[3]

[Anonymous], 2017, Disability statistics

[4]

Chowaniec A, 2021, 6 INT C ADH BOND, P83, DOI [10.1007/978-3-030-87668-56, DOI 10.1007/978-3-030-87668-56]

[5] The chemical and microstructural analysis of the adhesive properties of epoxy resin coatings modified using waste glass powder [J].

Chowaniec, Agnieszka ;

Sadowski, Lukasz ;

Zak, Andrzej .

APPLIED SURFACE SCIENCE, 2020, 504

[6]

Czarnecki L., 2021, IN BUD, V77, P300

[7] Epoxy-quartz based composites for use in polishing crowns of ornamental rocks [J].

de Oliveira, Odivan Coutinho ;

Bobrovnitchii, Guerold Sergueevitch ;

de Oliveira, Luciano Jose ;

da Rocha Paranhos, Ronaldo Pinheiro ;

Aigueira, Rafaela Barros ;

Filgueira, Marcello .

MATERIALS CHARACTERIZATION, 2009, 60 (08) :869-874

[8] Assessment of the Applicability of Sustainable Epoxy Composites Containing Waste Rubber Aggregates in Buildings [J].

Debska, Bernardeta ;

Licholai, Lech ;

Miasik, Przemyslaw .

BUILDINGS, 2019, 9 (02)

[9] Effect of functionalised and non-functionalised GNPs addition on strength of viscous adhesive and shear [J].

Ejaz, Hassan ;

Mubashar, A. ;

Uddin, Emad ;

Ali, Zaib ;

Arif, Nabeel .

POLYMER TESTING, 2022, 113

[10] Textile-reinforced mortars; an experimental comparative study of tensile strength improvement methods [J].

Ghasemi, Roohallah ;

Safarabadi, Majid ;

Haghighi-Yazdi, Mojtaba ;

Mirdehghan, Abolfazl .

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART L-JOURNAL OF MATERIALS-DESIGN AND APPLICATIONS, 2022, 236 (05) :1094-1107

← 1 2 3 →