共 31 条
An explorative study on the antimicrobial effects and mechanical properties of 3D printed PLA and TPU surfaces loaded with Ag and Cu against nosocomial and foodborne pathogens
被引:18
|作者:
Ekonomou, Sotirios, I
[1
]
Soe, Shwe
[2
]
Stratakos, Alexandros Ch
[1
]
机构:
[1] Univ West England, Coll Hlth Sci & Soc, Sch Appl Sci, Bristol BS16 1QY, Avon, England
[2] Univ West England, Coll Arts Technol & Environm, Sch Engn, Bristol BS16 1QY, Avon, England
关键词:
3D printing;
Polymers;
Biofilm;
Pathogens;
Healthcare;
Food sector;
SILVER NANOPARTICLES;
BIOFILM;
FABRICATION;
COMPOSITES;
REDUCTION;
POLYMERS;
VIEW;
D O I:
10.1016/j.jmbbm.2022.105536
中图分类号:
R318 [生物医学工程];
学科分类号:
0831 ;
摘要:
Antimicrobial 3D printed surfaces made of PLA and TPU polymers loaded with copper (Cu), and silver (Ag) nanoparticles (NPs) were developed via fused deposition modeling (FDM). The potential antimicrobial effect of the 3D printed surfaces against Escherichia coli, Listeria monocytogenes, Salmonella Typhimurium, and Staphylococcus aureus was evaluated. Furthermore, the mechanical characteristics, including surface topology and morphology, tensile test of specimens manufactured in three different orientations (XY, XZ, and ZX), water absorption capacity, and surface wettability were also assessed. The results showed that both Cu and Ag-loaded 3D printed surfaces displayed a higher inhibitory effect against S. aureus and L. monocytogenes biofilms compared to S. Typhimurium and E. coli biofilms. The results of SEM analysis revealed a low void fraction for the TPU and no voids for the PLA samples achieved through optimization and the small height (0.1 mm) of the printed layers. The best performing specimen in terms of its tensile was XY, followed by ZX and XZ orientation, while it indicated that Cu and Ag-loaded material had a slightly stiffer response than plain PLA. Additionally, Cu and Agloaded 3D printed surfaces revealed the highest hydrophobicity compared to the plain polymers making them excellent candidates for biomedical and food production settings to prevent initial bacterial colonization. The approach taken in the current study offers new insights for developing antimicrobial 3D printed surfaces and equipment to enable their application towards the inhibition of the most common nosocomial and foodborne pathogens and reduce the risk of cross-contamination and disease outbreaks.
引用
收藏
页数:12
相关论文