Temperature-Dependent Deformation Behavior of "γ-austenite/δ-ferrite" Composite Obtained through Electron Beam Additive Manufacturing with Austenitic Stainless-Steel Wire

Temperature dependence of tensile deformation behavior and mechanical properties (yield strength, ultimate tensile strength, and an elongation-to-failure) of the dual-phase (gamma-austenite/delta-ferrite) specimens, obtained through electron-beam additive manufacturing, has been explored for the first time in a wide temperature range T = (77-300) K. The dual-phase structures with a dendritic morphology of delta-ferrite (gamma + 14%delta) and with a coarse globular delta-phase (gamma + 6%delta) are typical of the as-built specimens and those subjected to a post-production solid-solution treatment, respectively. In material with lower delta-ferrite content, the lower values of the yield strength in the whole temperature range and the higher elongation of the specimens at T > 250 K have been revealed. Tensile strength and stages of plastic flow of the materials do not depend on the delta-ferrite fraction and its morphology, but the characteristics of strain-induced gamma ->alpha ' and gamma ->epsilon ->alpha ' martensitic transformations and strain-hardening values are different for two types of the specimens. A new approach has been applied for the analysis of deformation behavior of additively fabricated Cr-Ni steels. Mechanical properties and plastic deformation of the dual-phase (gamma + delta) steels produced through electron beam additive manufacturing have been described from the point of view of composite materials. Both types of the delta-ferrite inclusions, dendritic lamellae and globular coarse particles, change the stress distribution in the bulk of the materials during tensile testing, assist the defect accumulation and partially suppress strain-induced martensitic transformation.