Characterization and constitutive modeling of the high strain rate behavior of granite at low temperatures

被引:1
|
作者
Zhang, Xianqi [1 ]
Gong, Hangli [1 ,2 ]
Luo, Yi [1 ,2 ]
Peng, Junjie [3 ]
Li, Qiaoliang [1 ]
Yang, Chunneng [1 ]
机构
[1] Wuhan Univ Technol, Sch Civil Engn & Architecture, Wuhan 430070, Peoples R China
[2] Wuhan Univ Technol, Sanya Sci & Educ Innovat Pk, Sanya 572024, Peoples R China
[3] Guangdong Commun Planning & Design Inst Grp Co Ltd, Guangzhou 510507, Peoples R China
关键词
Saturated and frozen rocks; High strain rate; Dynamic damage constitutive relationship; Brittle characteristics; Failure modes; FRACTURE-TOUGHNESS; FROST HEAVE; ROCK; LAYER;
D O I
10.1007/s11043-024-09667-7
中图分类号
O3 [力学];
学科分类号
08 ; 0801 ;
摘要
A split Hopkinson pressure bar (SHPB) was used to characterize the high-strain rate behavior of saturated and frozen granite specimens. The effects of low temperatures and strain rates on dynamic mechanical response and failure behavior were investigated. The damage constitutive model of granite was established, considering both strain rate effect and low-temperature effect. The damage constitutive relationship took into account the statistical damage model based on Weibull distribution and nonlinear viscoelastic behavior. Results show that the dynamic compressive strength of the saturated and frozen granite at low temperatures (-20 degrees C to 15 degrees C) generally increases first and then decreases with the decrease of temperature. The peak strain decreases with the decrease of temperature and the peak strain at low temperatures (0 degrees C to -20 degrees C) decreases more than that at 15 degrees C. The dynamic Young's modulus of the samples shows an increasing trend from 0 degrees C to -20 degrees C, and the range of variation decreases with the decrease of temperature. At low temperature, the brittle characteristics of saturated granite are more pronounced due to water-ice phase change and cold shrinkage of the rock matrix, while the ductility is gradually reduced. The modeling results on the stress-strain relationships are consistent with experimental data. It is verified that the constitutive relationship can describe the high strain rate characteristics of saturated frozen granite.
引用
收藏
页码:2681 / 2704
页数:24
相关论文
共 50 条
  • [1] Experimental Characterization and Modified Constitutive Modeling of the Strain Rate Dependent Compressive Behavior of Adhesives
    Li, Peifeng
    Wang, Zhiyong
    MACROMOLECULAR MATERIALS AND ENGINEERING, 2016, 301 (05) : 577 - 585
  • [2] Constitutive modeling of ice in the high strain rate regime
    Sain, Trisha
    Narasimhan, R.
    INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES, 2011, 48 (05) : 817 - 827
  • [3] High strain rate constitutive modeling for natural rubber
    Fatt, M. S. Hoo
    Al-Quraishi, A. A.
    CONSTITUTIVE MODELS FOR RUBBER V, 2008, : 53 - 60
  • [4] Experimental characterization and constitutive modeling of the non-linear stress–strain behavior of unidirectional carbon–epoxy under high strain rate loading
    Koerber H.
    Kuhn P.
    Ploeckl M.
    Otero F.
    Gerbaud P.-W.
    Rolfes R.
    Camanho P.P.
    Advanced Modeling and Simulation in Engineering Sciences, 5 (1)
  • [5] Analysis and constitutive modeling of high strain rate deformation behavior of Haynes 282 aerospace superalloy
    Ugodilinwa, Nnaemeka Emmanuel
    Khoshdarregi, Matt
    Ojo, Olanrewaju Akanbi
    MATERIALS TODAY COMMUNICATIONS, 2019, 20
  • [6] Strain rate dependent tensile behavior of advanced high strength steels: Experiment and constitutive modeling
    Kim, Ji-Hoon
    Kim, Daeyong
    Han, Heung Nam
    Barlat, F.
    Lee, Myoung-Gyu
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2013, 559 : 222 - 231
  • [7] Compressive behavior and constitutive model of polyurea at high strain rates and high temperatures
    Liu, Qiang
    Chen, Pengwan
    Zhang, Yang
    Li, Zhirong
    MATERIALS TODAY COMMUNICATIONS, 2020, 22
  • [8] Constitutive modeling of polycarbonate during high strain rate deformation
    Safari, Keivan H.
    Zamani, Jamal
    Ferreira, Fernando J.
    Guedes, Rui M.
    POLYMER ENGINEERING AND SCIENCE, 2013, 53 (04): : 752 - 761
  • [9] Constitutive modeling of nitrogen-alloyed austenitic stainless steel at low and high strain rates and temperatures
    Abed, Farid H.
    Ranganathan, Shivakumar I.
    Serry, Mohamed A.
    MECHANICS OF MATERIALS, 2014, 77 : 142 - 157
  • [10] Effect of High Temperature and Inclination Angle on Mechanical Properties and Fracture Behavior of Granite at Low Strain Rate
    Chen, Liang
    Mao, Xianbiao
    Wu, Peng
    SUSTAINABILITY, 2020, 12 (03)