Low-Temperature Plasma-Assisted Catalytic Dry Reforming of Methane over CeO2 Nanorod-Supported NiO Catalysts in a Dielectric Barrier Discharge Reactor

Nonthermal plasma (NTP)-assisted catalytic dry reforming of methane (DRM) is considered a powerful single-stage reaction mechanism because of its ability to activate normally stable CO2 and CH4 at a low temperature under ambient conditions. The thermodynamic barrier of DRM requires a high operating temperature (>700 degrees C), which can be reduced by nonequilibrium plasma. Herein, we present a method for the wet-impregnation synthesis of CeO2 nanorod (NR)-supported 5 and 15 wt % NiO catalysts for efficient NTP-promoted DRM with an applied power in the range of 24.9-25.8 W (frequency: 20 kHz), a CH4:CO2 feed gas ratio of 100:250 sccm, and a total flow rate of 350 sccm. The presence of NTP dramatically increased the reaction activity, even at 150 degrees C, which is usually inaccessible for thermally catalyzed DRM. The CH4 and CO2 conversion reaches a maximum of 66 and 48%, respectively, at 500 degrees C with the 15 wt % NiO/CeO2 NR catalyst, which are much higher than the values obtained for the 5 wt % NiO/CeO2 NR catalyst under the same conditions. According to the X-ray photoelectron spectroscopy profile for 15 wt % NiO/CeO2 NR, a higher concentration of NiO on CeO2 increases the proportion of Ce3+ in the catalyst, suggesting enhanced oxygen vacancy concentration with an increased amount of NiO loading. Additionally, a higher NiO loading promotes a higher rate of replacement of Ce4+ with Ni2+, which generates more oxygen vacancies due to the induced charge imbalance and lattice distortion within the CeO2 lattice. As a result, it can be inferred that the incorporation of Ni ions into the CeO2 structure resulted in inhibited growth of CeO2 crystals due to the creation of a NixCe1-xO2-alpha solid solution and the production of oxygen vacancies.