Validation of the distal filling ratio in uncemented convertible short-stem shoulder arthroplasty

Introduction Radiographic stress shielding is a common finding in uncemented convertible short-stem shoulder arthroplasty (UCSSSA). The distal filling ratio (DFR) has been described as a predictor for the occurrence of stress shielding. A DFR > 70% was mentioned as a risk factor for the occurrence of stress shielding for some UCSSSA. However, measurements were only performed on conventional radiographs and no validation exists for 3D automated planning tools. Methods DFR was manually measured on postoperative true ap radiographs of 76 shoulder arthroplasties using a standardized protocol and were compared to preoperative CT scans with an automated calculation of the DFR after virtual implantation of the stem. Results The mean DFR measured on X-rays was 75.9% (SD = 8.7; 95% CI = 74-78) vs. 78.9% (SD = 9.1; 95% CI = 76.8-83) automatically measured on CT scans. This difference was significant (p < 0.001). In 7 out of 76 cases (9%) the difference between manual measurement on radiographs and computerized measurement on CT scans was > 10%. Conclusion Manual measurement of the DFR is underestimated on conventional radiographs compared to automated calculation on CT scans be a mean of 3%. Therefore, automated measurement of the DFR on CT scans seems to be beneficial, especially in cases with osteopenic cortices. Manual measurement of the DFR on conventional ap radiographs in cases without CT scans, however, is still a viable alternative.