Innovative experimental approach for the dynamic Multi-Variable investigation of Pulsating heat Pipes

Pulsating Heat Pipes (PHP) are passive two-phase heat transfer devices characterized by a simple structure and high heat transfer capabilities. Despite this, their large-scale application is still hindered by the actual unpre-dictability of their dynamic behavior during the startup and the thermal crisis. An innovative experimental apparatus is designed to systematically investigate the above-mentioned phenomena. It consists in a square loop made of four borosilicate transparent glass tubes joined at corners by means of brass connectors. The external tube surface is coated with several transparent Indium Tin Oxide heaters. The device is used to topologically reproduce 5, 7, and 11 evaporator/condenser sections PHPs with a 2 mm inner diameter tube, filled with pure ethanol and tested in horizontal position. First a steady-state characterization is performed. The condenser temperature is varied from 10 degrees C to 40 degrees C; the input power goes from 10 W to 40 W. Results show that both the increase of number of evaporator sections and condenser temperature enhance the PHP performance in terms of equivalent thermal resistance. Then, the effect of the condenser temperature on the initial liquid phase distri-bution is analyzed. It is observed that at low condenser temperatures (10 degrees C, 20 degrees C), the liquid phase tends to gather in the condenser sections rather than the evaporator sections and it is arranged in short liquid plugs; conversely, for high condenser temperatures (30 degrees C, 40 degrees C), the amount of liquid phase in evaporators is higher and it is arranged in long liquid plugs. Finally, the transient behavior is studied in terms of startup time. It is observed that the parameter influencing most the startup time is the initial fluid distribution; the startup time increases with the increase of evaporator sections volume occupied by liquid phase and with the length of liquid plugs; on the other hand, the startup time decreases with the increase of number of menisci in the evaporator sections.