Implementation of an Advanced Constitutive Models for Fine-Grained Soils

被引:2
作者
Bouri, Djamel Eddine [1 ,2 ]
Brahimi, Abdelkader [3 ,4 ]
Belhassena, Fatima Zohra [5 ]
Krim, Abdallah [3 ,6 ]
Arab, Ahmed [3 ]
Najser, Jan [7 ]
Masin, David [7 ]
机构
[1] Ecole Natl Super Hydraul Blida, GEE, Soumaa, Algeria
[2] Univ Ctr Ain Temouchent, Smart Struct Lab, Ain Temouchent, Algeria
[3] Hassiba Ben Bouali Univ Chlef, Lab Mat Sci & Environm, Ouled Fares 02000, Algeria
[4] Univ Ctr Abdelhafid Boussouf Mila, Inst Sci & Technol, Dept Sci & Technol Mila, Mila, Algeria
[5] Harbin Inst Technol, Sch Civil Engn, Harbin 150090, Peoples R China
[6] Ibn Khaldoun Univ Tiaret, Tiaret 14000, Algeria
[7] Charles Univ Prague, Fac Sci, Prague, Czech Republic
关键词
Fine content; Hypoplastic; Model; Sand; Void ratio; UNDRAINED SHEAR-STRENGTH; SILTY SAND; LIQUEFACTION RESISTANCE; COMPRESSIONAL BEHAVIOR; STATIC LIQUEFACTION; STRESS;
D O I
10.1007/s10706-023-02465-x
中图分类号
P5 [地质学];
学科分类号
0709 ; 081803 ;
摘要
This article presents the effect of silt proportion on the hypoplastic parameters (exponent n, granular hardness hs, exponent a, and exponent beta) used for numerical simulation, calculation of emax, and transitional fines content (Fct). Fifteen oedometer tests were carried out at various relative densities (RD = 30, 65, and 80%) to evaluate their effect on the compressibility parameters such as compression index Cc, secant oedometer modulus E-secant, and pre-consolidation pressure sigma'p. Additionally, ten monotonic undrained triaxial tests were conducted at RD = 65% and RD = 80% to determine the value of the a parameter used in numerical simulation. The results obtained indicate that that the void ratio decreases with the increasing proportion of fine fraction up to 30% and further decreases with an additional increase of fines up to 40% for the three cases of relative densities (RD = 30, 65 and 80%). Additionally, it is shown from our results that the hypoplastic model is able to simulate soil behavior under undrained and oeodometer conditions. It was found that an increase in the a parameter leads to an increase in the dilatancy of the curves observed in the triaxial test. On the other hand, the parameters a and beta seem to have no effect on the compressibility curves, and it was necessary to rely on their physical parameters. The transitional fines content (F-ct) F-Ct F-Ct depends on the stress level and maximum void ratio, which are calculated from the parameters of the hypoplastic model (eio, hs, ps, n).
引用
收藏
页码:3403 / 3425
页数:23
相关论文
共 62 条
[1]   A laboratory study of shear strength of partially saturated sandy soil [J].
Abdallah, Krim ;
Abdelkader, Brahimi ;
Ahmed, Arab ;
Djamel Eddine, Bouri ;
Marwan, Sadek .
GEOMECHANICS AND GEOENGINEERING-AN INTERNATIONAL JOURNAL, 2022, 17 (03) :741-750
[2]   Laboratory Investigation of the Influence of Geotextile on the Stress–Strain and Volumetric Change Behavior of Sand [J].
Abdelkader B. ;
Arab A. ;
Sadek M. ;
Shahrour I. .
Sadek, Marwan (Marwan.Sadek@polytech-lille.fr), 2018, Springer International Publishing (36) :2077-2085
[3]   Laboratory study of geotextiles performance on reinforced sandy soil [J].
Abdelkader, Brahim ;
Ahmed, Arab ;
Mostefa, Belkhatir ;
Isam, Shahrour .
JOURNAL OF EARTH SCIENCE, 2016, 27 (06) :1060-1070
[4]   Undrained Response and Liquefaction Resistance of Sand-Silt Mixtures [J].
Akhila, M. ;
Rangaswamy, K. ;
Sankar, N. .
GEOTECHNICAL AND GEOLOGICAL ENGINEERING, 2019, 37 (04) :2729-2745
[5]   Liquefaction testing of stratified silty sands [J].
Amini, F ;
Qi, GZ .
JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING, 2000, 126 (03) :208-217
[6]  
[Anonymous], 1997, D2435D2435M ASTM
[7]  
[Anonymous], 2002, Annual Book of ASTM Standards, P1, DOI [10.1520/D4253-16E01, DOI 10.1520/D4253-16E01]
[8]   Monotonic Preloading Effect on the Liquefaction Resistance of Chlef Silty Sand: a Laboratory Study [J].
Arab, A. ;
Sadek, M. ;
Belkhatir, M. ;
Shahrour, I. .
ARABIAN JOURNAL FOR SCIENCE AND ENGINEERING, 2014, 39 (02) :685-694
[9]   A laboratory study of liquefaction of partially saturated sand [J].
Arab, A. ;
Shahrour, I. ;
Lancelot, L. .
JOURNAL OF IBERIAN GEOLOGY, 2011, 37 (01) :29-36
[10]   On monotonic and cyclic behavior of silty sand [J].
Arab, Ahmed .
COMPTES RENDUS MECANIQUE, 2009, 337 (08) :621-631