Modeling and analysis of radial throw of micro-milling tool based on tool-attachment errors in high-speed rotating

In the process of micro-milling complex structures, radial throw is likely to cause lower dimensional/form accuracy, which will severely affect the performance of the components. Therefore, it is necessary to investigate the source contributing to the radial throw. According to the kinematic process of the radial throw arising from the attachment errors of the micro milling cutters, a mathematical model considered the attachment errors and the variable section geometry of the micro milling cutters was established to predict the radial throw on the basis of the principle of minimum total potential energy and the Timoshenko beam theory. In comparison to the mathematical model, the proposed finite element model (FEM) presetting the attachment errors shows the effect of modal vibration and the variation of radial throw with attachment errors. To further investigate the environmental factors influencing the radial throw, a measurement method based on the laser measurement system is presented to achieve the on-machine measurement of runout, and a specific extraction method of attachment errors was proposed to help validate the mathematical model. The difference between the results of the mathematical model, FEM, and the experiment is not exceeding 10 % within 3 mu m of the maximum runout. Radial throw varies strongly with attachment errors, and the high rotation speed will aggravate the system instability caused by the attachment errors. The main contributor among experimental factors to the variation of runout is the form accuracy of micro milling cutters, accounting for 4.7 % at the highest. This method can provide a theoretical basis for the sources of unbalanced cutting force analysis and the improvement of dimensional/form accuracy.