Evolution mechanism of water column separation in pump turbine: Model and occurrence criterion

Whether the superposition of pressure pulsation and water hammer pressure caused by the fast closing of guide vanes causes water column separation in draft tube inlets is a hot topic in engineering and academic fields. It is also not known whether the bridging of water column separation endangers the operation of the units. This study uses a model pumped storage power station platform with two units to perform water column separation. Data on the pressure pulsation at different measurement points, discharges, and speeds are collected by an acquisition system, whereas the development process of water column separation is characterized by a high-speed camera. The measured pressure is decomposed into the water hammer pressure, which migrates with the unit operation point and pressure pulsation. The test results reveal that the pressure in the inlet section of the draft tube below the vaporization pressure that lasts for several seconds is a sufficient and necessary condition for water column separation to occur. The water hammer pressure has a significant influence on the water column separation, while low-frequency pressure pulsation has less influence. Water column separation is divided into four stages: starting, improvement, separation, and bridging. The main frequency of the pressure pulsation in the water column separation process is the frequency of the water hammer caused by load rejection and has a value of 0.47f/fn. Cavity bridging generates a frequency of 0.30f/fn. The flow-speed curve remains in the braking con-dition of turbine for 1.25 s. The separation and part of the bridging stage occur under the braking condition of turbine.