Effect of injection pressure on low-temperature fuel atomization characteristics of diesel engines under cold start conditions

被引：5
作者：
Wang, Xiaoran [1 ]
Li, Hongmeng [1 ]
Li, Guoxiu [1 ]
Fan, Juting [2 ]
Bai, Honglin [2 ]
Gao, Yang [1 ]
Huo, Haobo [1 ]
机构：
[1] Beijing Jiaotong Univ, Sch Mech Elect & Control Engn, Beijing 100044, Peoples R China
[2] China North Engine Res Inst, Tianjin 300400, Peoples R China
来源：
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW | 2024年 / 172卷
关键词：
Engine cold start condition; PIV measurements; Laser induced exciplex fluorescence(LIEF); Low temperature fuel; Spray-wall impingement; Vapor phase concentration; WALL IMPINGEMENT; SPRAY;
D O I：
10.1016/j.ijmultiphaseflow.2023.104712
中图分类号：
O3 [力学];
学科分类号：
08 ; 0801 ;
摘要：
Exploring the atomization characteristics and spray impingement characteristics of low-temperature fuel under different injection pressures has important practical significance for improving the cold start performance of diesel engines. In this study, based on LIEF-PIV combined laser testing technology, a fuel atomization experimental system for diesel engine cold start was established. The concentration and velocity fields of low-temperature fuel with the temperature from 20 to -40 degrees C were experimentally analyzed within the injection pressures of 40-80MPa. The results showed that the increase of injection pressure increased the initial kinetic energy of the diesel droplets, whereas the concentration gradient of spray decreased significantly. Meanwhile, the mixing effect of spray and ambient gas increased. When the fuel temperature decreased from 0 degrees C to -20 degrees C, the values of the average equivalence ratio in the near-wall region decreased from 0.52 to 0.21. The change of injection pressure had an obvious effect on the macro morphology of wall-impinging spray and the flow characteristics of the fuel/air mixture. When the injection pressure increased from 40MPa to 80MPa, the difference of maximum turbulent kinetic energy among various temperatures increased from 0.66 m2/s2 to 0.90 m2/s2.
引用
收藏
页数：11
相关论文
共 34 条
  • [11] Characteristics of in-cylinder flow and mixture formation in a high-pressure spray-guided gasoline direct-injection optically accessible engine using PIV measurements and CFD
    Kim, Donghwan
    Shin, Jisoo
    Son, Yousang
    Park, Sungwook
    [J]. ENERGY CONVERSION AND MANAGEMENT, 2021, 248
  • [12] Acting mechanism of low ambient temperature on wall-impinging diesel spray ignition at an extensive range
    Li, Yaozong
    Li, Xiangrong
    Cao, Weiren
    Shi, Zhicheng
    Bo, Yaqing
    Wu, Han
    [J]. FUEL, 2021, 304
  • [13] Study on the First-Firing-Cycle combustion characteristics of high-altitude and low-temperature environments during diesel engine cold start
    Liang, Fang
    Diming, Lou
    Zhiyuan, Hu
    Piqiang, Tan
    Yunhua, Zhang
    Rong, Yang
    [J]. FUEL, 2022, 322
  • [14] Experimental study on the combustion characteristics of impinging diesel spray at low temperature environment
    Liu, Fushui
    Yang, Ziming
    Li, Yikai
    Wu, Han
    [J]. APPLIED THERMAL ENGINEERING, 2019, 148 : 1233 - 1245
  • [15] An investigation on a diesel jet's ignition characteristics under cold-start conditions
    Liu, Fushui
    Zhang, Zheng
    Wu, Han
    Li, Yikai
    Ma, Yupo
    Li, Xiangrong
    Du, Wei
    [J]. APPLIED THERMAL ENGINEERING, 2017, 121 : 511 - 519
  • [16] Cold start control strategy for a two-stroke spark ignition diesel-fuelled engine with air-assisted direct injection
    Liu, Rui
    Wei, Minxiang
    Yang, Haiqing
    [J]. APPLIED THERMAL ENGINEERING, 2016, 108 : 414 - 426
  • [17] Co-evaporative multi-component fuel design for in-cylinder PLIF measurement and application in gasoline direct injection research
    Ma, Xiao
    He, Xu
    Wang, Jian-xin
    Shuai, Shijin
    [J]. APPLIED ENERGY, 2011, 88 (08) : 2617 - 2627
  • [18] Prediction of wall impingement in a direct injection spark ignition engine by analyzing spray images for high-pressure injection up to 50 MPa
    Park, Junkyu
    Kim, Taehoon
    Kim, Donghwan
    Park, Sungwook
    [J]. FUEL PROCESSING TECHNOLOGY, 2018, 179 : 238 - 249
  • [19] Fuel concentration in isothermal Diesel sprays through structured planar laser imaging measurements
    Payri, R.
    Gimeno, J.
    Marti, P.
    Manin, J.
    [J]. INTERNATIONAL JOURNAL OF HEAT AND FLUID FLOW, 2012, 34 : 98 - 106
  • [20] Velocity field analysis of the high density, high pressure diesel spray
    Payri, Raul
    Viera, Juan P.
    Wang, Hua
    Malbec, Louis-Marie
    [J]. INTERNATIONAL JOURNAL OF MULTIPHASE FLOW, 2016, 80 : 69 - 78
1234