Introducing lamellar LPSO phase to regulate room and high-temperature mechanical properties of Mg-Gd-Y-Zn-Zr alloys by altering cooling rate

The mechanical properties of the extruded and peak-aged Mg-12.8Gd-4.7Y-2.6Zn-0.9Zr (wt.%) (GWZ1352) alloys at room and high temperatures were systematically investigated with respect to their microstructures. The microstructural features were tailored through altering the cooling rates after homogenization by water-quenching, air-cooling and furnace-cooling, respectively. As the cooling rate reduced, the number of lamellar long period stacking ordered (LPSO) phase increased substantially and its spacing decreased gradually. Additionally, solute segregation at grain boundaries occurred after furnacecooling. After extrusion, the quenching (QE) alloy exhibited nearly full dynamic recrystallized (DRXed) grains, whereas the air-cooling (AE) and furnace-cooling (FE) alloys displayed a typical bimodal structure consisting of fine DRXed and coarse un-DRXed grains. The nucleation and development of the DRXed grains were hampered by the nano-spaced lamellar LPSO phase and the solute segregation of grain boundary. The excellent high temperature mechanical properties of the FE alloy were mostly due to the abundant lamellar LPSO phase. After aging treatment, plentiful fine b0 phase was precipitated in the quenching and aged (QEA) alloy. In contrast, the b0 phase with a larger size and lower density, accompanied with a wide precipitation-free zone (PFZ) at grain boundaries was formed in the air-cooling and aged (AEA) and furnace-cooling and aged (FEA) alloys, which severely deteriorated their mechanical properties both at room and high temperatures.& COPY; 2023 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).