Investigation of deformation comprised microstructure and precipitation of Cu-Sn-Ti alloy during hot deformation

The hot deformation behavior of Cu-Sn-Ti-(Cr) alloys was studied using Gleeble-1500D thermo-mechanical simulator ranging from 550 to 950 degrees C, and the strain rate was 0.001 -10 s-1. The microstructure evolution of the alloy was analyzed using characterization methods such as electron backscatter diffraction (EBSD), scanning electron microscope (SEM) and transmission electron microscope (TEM). Cu-Sn-Ti-(Cr) alloys were calculated by establishing the constitutive equation of the alloy. The activation energies of Cu-Sn-Ti and Cu-Sn-Ti-Cr alloys are 275.884 and 283.550 kJ/mol, respectively. The results indicate that the addition of Cr element has an inhibitory effect on the nucleation and improve refinement of dynamic recrystallization (DRX) in Cu-Sn-Ti alloy. The texture of Cu-Sn-Ti alloy is Cu texture at 750 degrees C and the texture contained in Cu-Sn-Ti alloy is Goss texture, Cubic texture and Cu texture when the temperature is raised to 950 degrees C. The texture of Cu -Sn-Ti-Cr alloy at 750 degrees C is Goss texture. The Goss texture transforms into Cubic texture and Cu texture when the temperature is raised to 950 degrees C. The precipitates present in Cu-Sn -Ti alloy include CuSn3Ti5 phase and Cu4Ti phase. The addition of Cr element adds a new phase of Cr to the alloy and also makes the distribution of precipitates more uniform and increases in quantity. (c) 2023 Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).