Development of ultrahigh-strength low-alloy Mg-0.7Al-0.3Ca-0.4Mn (wt.%) alloy with excellent ductility via controlling extrusion temperature

Mg-0.7Al-0.3Ca-0.4Mn (AXM070304, wt.%) alloy was subjected to extrusion with a ram speed of 1 mm/s and an extrusion ratio of 25:1. The extrusion temperature varies from 170 degrees C to 400 degrees C. The influence of extrusion temperature on microstructure and mechanical properties of the dilute AXM070304 alloy was systematically explored. With raising the extrusion temperature, the average size of the dynamic recrystallized (DRXed) grains was increased, while the intensity of the basal fiber texture was decreased. When the extrusion temperature was escalated from 170 degrees C to 400 degrees C, the tensile yield strength (YS) of the lowalloy AXM070304 extrusion alloy was decreased from 437 to 246 MPa, while the elongation to failure (EL) was increased from 2.9 to 16.9%. The alloy extruded at 200 degrees C obtains an YS of 412 MPa, an ultimate tensile strength (UTS) of 418 MPa and an EL of 14.8%, exhibiting excellent ductility and ultrahigh strength. The ultrahigh YS was mainly due to the strengthening from ultra-fine recrystallized grains (0.61 mm) with grain boundary segregation of solute Al and Ca atoms. The growth of DRXed grains was inhibited mainly by the co-segregation of Al atoms and Ca atoms, nanosized Al2Ca and b-Mn particle phases at the grain boundaries. Plastic instability occurred under tensile loading in the ultrafine-grained AXM070304 alloy, which may be due to the fact that the grain boundary segregation of Al atoms and Ca atoms requires a high energy barrier for dislocation emission. Once the tensile stress reaches the peak value, the mobile dislocation density increases suddenly. (c) 2023 The Authors. Published by Elsevier B.V. This is an open access article under the CC