The microstructure and mechanical properties of 316L austenitic stainless steel prepared by forge and laser melting deposition

In this study, the 316L austenitic stainless steel blocks were prepared by forge and laser melting deposition (LMD). To clarify the effect of deposition strategy on microstructure and mechanical properties of 316L samples, three different deposition strategies (30 degrees, 67 degrees and 90 degrees) are selected. The results showed that the molten pool of LMDed sample consists of a large number of coarse columnar grains and a few irregular equiaxed grains, which contains plentiful cellular and fiber sub-structures with an average size of similar to 4 mu m. The LMD process can significantly improve the comprehensive mechanical properties perpendicular to the build direction of 316L austenitic stainless steel, which was mainly attributed to sub-structural strengthening, but also slightly due to the local misorientation and texture distribution. The yield strength and ultimate tensile strength of R90 sample increased to 484.0 MPa and 627.6 MPa from 305.3 MPa to 601.4 MPa of as-forged 316L, and its elongation has a negligible reduction. The sub-structures produced during solidification have the same fine grain strengthening effect as the high-angle grain boundary, and the yield strength and average size of sub-structures conform to the Hall-Petch relationship. The deterioration of the plastic deformation capacity of the R67 sample is attributed to the larger thermal stress and texture distribution with a certain hard orientation. The plastic deformation of as-forged sample is mainly coordinated by multi-system slip, while twinning and slip are activated together during deformation of LMDed 316L austenitic stainless steel. The grain boundary map indicated that the strain location preferentially appears along cell wall of sub-structures, which promotes the formation of sub-grain boundaries during deformation of LMDed samples.