Partial austenitisation and TBF steel composed of ferrite, bainitic ferrite, and austenite

被引：2

作者：

Erisir, Ersoy ^{[1
]}

Bilir, Oguz Gurkan ^{[1
]}

Sozer, Yunus Emre ^{[2
]}

Ararat, Ozge ^{[1
]}

Davut, Kemal ^{[3
]}

机构：

[1] Kocaeli Univ, Dept Met & Mat Engn, Kocaeli, Turkey

[2] Erdemir, Eregli Demir & Celik Fabrikalari TAS, Zonguldak, Turkey

[3] Izmir Inst Technol, Mat Sci & Engn Dept, Urla Izmir, Turkey

来源：

MATERIALS SCIENCE AND TECHNOLOGY | 2023年 / 39卷 / 01期

关键词：

TBF steels; partial austenitisation; phase transformations; microstructural characterisation; mechanical properties; MECHANICAL-PROPERTIES; STRENGTH; MICROSTRUCTURE; MARTENSITE; FORMABILITY; DUCTILITY; EBSD; NB; ALUMINUM;

D O I：

10.1080/02670836.2022.2102289

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

A TRIP-aided bainitic-ferritic (TBF) steel with a chemical composition of Fe-0.19C-1.7Mn-1.09Si-0.51Al-0.05Nb (wt-%) was partially austenitised from a hot-rolled martensitic initial microstructure. After the hot rolling, the martensitic specimens were reheated to different intercritical temperatures and then austempered at 350 degrees C. Thus, the effect of the initial microstructure of TBF steel on intercritical austenite formation during partial austenitisation was studied. The microstructures were investigated by scanning electron microscopy and electron backscatter diffraction (EBSD), and the tensile properties were tested. Microstructural observations revealed that a final microstructure of fine ferrite, bainitic ferrite, and retained austenite can be obtained. The steel partial austenitised at 770 degrees C showed a good combination of ultimate tensile strength and total elongation.

引用

页码：105 / 116

页数：12

共 50 条

[31] Austenite and ferrite grain sizes in interstitial free steel
Akbari, G. H.
Sellars, C. M.
Whiteman, J. A.
Materials Science and Technology, 11 (12):
[32] Austenite and ferrite grain sizes in interstitial free steel
Department of Engineering Materials, University of Sheffield, United Kingdom
Mater. Sci. Technol., 12 (1261-1265):
[33] Room temperature texturing of austenite/ferrite steel by electropulsing
Rahnama, Alireza
Qin, Rongshan
SCIENTIFIC REPORTS, 2017, 7
[34] The Effect of Primary Ferrite on Bainitic Transformation, Microstructure, and Properties of Low Carbon Bainitic Steel
Man Liu
Guang Xu
Junyu Tian
Zhenye Chen
Ziliu Xiong
Metal Science and Heat Treatment, 2020, 62 : 306 - 314
[35] Bainitic ferrite fine twins in bainitic steels
Li, F.Z.
Ao, Q.
Meng, F.Y.
Meng, X.M.
Liu, Y.X.
Cailiao Rechuli Xuebao/Transactions of Materials and Heat Treatment, 2001, 22 (02):
[36] The Effect of Primary Ferrite on Bainitic Transformation, Microstructure, and Properties of Low Carbon Bainitic Steel
Liu, Man
Xu, Guang
Tian, Junyu
Chen, Zhenye
Xiong, Ziliu
METAL SCIENCE AND HEAT TREATMENT, 2020, 62 (5-6) : 306 - 314
[37] Formability Evaluation of TRIP-aided Steel Sheets with Different Microstructures: Polygonal Ferrite and Bainitic Ferrite
Emadoddin, E.
Asmari, H.
Zadeh, A. Habibolah
INTERNATIONAL JOURNAL OF MATERIAL FORMING, 2009, 2 : 781 - 784
[38] Correlation Between the Microstructural Development of Bainitic Ferrite and the Characteristics of Martensite-Austenite Constituent
Hidenori Terasaki
Yu-ichi Komizo
Metallurgical and Materials Transactions A, 2013, 44 : 5289 - 5293
[39] Correlation Between the Microstructural Development of Bainitic Ferrite and the Characteristics of Martensite-Austenite Constituent
Terasaki, Hidenori
Komizo, Yu-ichi
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2013, 44A (12): : 5289 - 5293
[40] Formability Evaluation of TRIP-aided Steel Sheets with Different Microstructures: Polygonal Ferrite and Bainitic Ferrite Matrix
E. Emadoddin
H. Asmari
A. Habibolah Zadeh
International Journal of Material Forming, 2009, 2

← 1 2 3 4 5 →