Acoustic properties of glued laminated bamboo and spruce-pine-fir

被引:3
|
作者
Kong, Youbohong [1 ]
Wen, Jie [1 ,2 ,4 ]
Huang, Anxu [1 ]
Zhou, Lejun [1 ]
Xiao, Yan [1 ,2 ,3 ]
机构
[1] Zhejiang Univ, Zhejiang Univ Univ Illinois Joint Inst, Haining, Peoples R China
[2] Zhejiang Univ Co Ltd, Architectural Design & Res Inst, Ctr Balance Architecture, Hangzhou, Peoples R China
[3] Univ Southern Calif, Dept Civil & Environm Engn, Los Angeles, CA USA
[4] Zhejiang Univ, Zhejiang Univ Univ Illinois Joint Inst, Haining 314400, Peoples R China
基金
中国国家自然科学基金;
关键词
Bamboo-based materials; sound insulation index; sound absorption coefficient; impedance tube method; SOUND-TRANSMISSION; INSULATION; NOISE;
D O I
10.1080/17480272.2023.2187318
中图分类号
TB3 [工程材料学]; TS [轻工业、手工业、生活服务业];
学科分类号
0805 ; 080502 ; 0822 ;
摘要
Noise pollution has become a worldwide issue, which has a negative effect on human health. The sound reduction index and absorption coefficient of glued laminated bamboo (glubam) and spruce-pine-fir (SPF) were firstly measured in this study by using the impedance tube method. The effect of moisture content on the acoustic performance of these materials was also investigated. Experimental results revealed that for thick-strip glubam and SPF, the higher moisture content, the higher sound reduction index but lower sound absorption coefficient. However, moisture content does not have an obvious effect on acoustic properties of thin-strip glubam. By comparing with other materials, it can be found that glubam and SPF have relatively high normal-incidence transmission loss but low absorption coefficient and noise reduction coefficient. Glubam shows the similar but even better acoustic insulation performance than SPF, which confirms the possibility of using glubam as an alternative of wood materials. Moreover, a finite element model was built up to simulate the measurement of sound transmission loss in an impedance tube. Some parametric studies were then conducted using the finite element model to prove the effectiveness of increasing thickness, using composites and double-layer panels on improving the soundproof performance of materials.
引用
收藏
页码:1765 / 1779
页数:15
相关论文
共 50 条
  • [1] Experimental investigation into bending performance of nail-laminated timber fabricated with spruce-pine-fir
    Li Z.
    Feng W.
    He M.
    Jianzhu Jiegou Xuebao/Journal of Building Structures, 2023, 44 (10): : 106 - 113
  • [2] A Comparison of Drying Strategies for Spruce-Pine-Fir Dimension Lumber
    Cai, Liping
    Oliveira, Luiz C.
    FOREST PRODUCTS JOURNAL, 2011, 61 (08) : 681 - 684
  • [5] Physical and Mechanical Properties of Glued Laminated Bamboo
    de Lima, Douglas Mateus
    Lima Junior, Humberto Correia
    Medeitos, Ialysson da Silva
    BIORESOURCES, 2023, 18 (02) : 3522 - 3539
  • [6] Mechanical properties of Colombian glued laminated bamboo
    Correal, J.
    Lopez, L.
    MODERN BAMBOO STRUCTURES, 2008, : 121 - +
  • [7] Flexural Behavior of Hybrid Cross-Laminated Timber Fabricated from Construction Oriented Strand Board and Spruce-Pine-Fir
    Li Q.
    Wang Z.
    Liang Z.
    Li L.
    Linye Kexue/Scientia Silvae Sinicae, 2021, 57 (11): : 158 - 168
  • [8] Influence of high strain-rates on the dynamic flexural material properties of spruce-pine-fir wood studs
    Jacques, Eric
    Lloyd, Alan
    Braimah, Abass
    Saatcioglu, Murat
    Doudak, Ghasan
    Abdelalim, Omar
    CANADIAN JOURNAL OF CIVIL ENGINEERING, 2014, 41 (01) : 56 - 64
  • [9] HIGH-TEMPERATURE DRYING EFFECT ON BENDING STRENGTH OF SPRUCE-PINE-FIR JOISTS
    HUFFMAN, DR
    FOREST PRODUCTS JOURNAL, 1977, 27 (03) : 55 - 57
  • [10] EDGE-GLUING UNSEASONED SPRUCE-PINE-FIR LUMBER USING A PREHEATING METHOD
    TROUGHTON, GE
    CASILLA, RC
    FOREST PRODUCTS JOURNAL, 1983, 33 (05) : 38 - 44