On the surface segregation of Sn in cold-rolled Fe under continuous annealing conditions

The surface segregation of Sn in cold -rolled Fe-0.03Sn and Fe-0.01Sn (at.%) model alloys was investigated for annealing parameters characteristic of continuous galvanizing lines (CGLs). The most significant increase in surface coverage occurred during linear heating between 500 and 675 degrees C, where no significant change in segregation was observed with isothermal holding for 60 - 480 s at peak annealing temperatures of 675 - 825 degrees C. While the bulk diffusion of Sn in Fe determined the segregation rate during extended isothermal holding up to 10800 s, it could not account for the rapid increase in coverage during heating. It was determined that Sn segregation was accelerated during linear heating by rapid diffusion along dislocation pipes in the cold -rolled starting microstructure. Integrating the decrease in diffusivity due to recrystallization into the McLean model for interfacial segregation resulted in an experimentally verified description of segregation kinetics during linear heating. It was also able to predict the experimentally observed increase in segregation when the linear heating rate between 500 degrees C and 675 degrees C was decreased from 5 to 1 degrees C/s. No significant difference in surface segregation was observed between the 0.01 and 0.03 at.% Sn addition for isothermal holding of 480 s or less, which can be explained by the saturation of easy adsorption sites. A bond -breaking model was used to illustrate their origin from imperfect coordination within the surface layer. As significant surface segregation can be achieved within the CGL processing window, Sn microalloying appears as a promising strategy to improve galvanized coating quality.