Heat transfer and pressure drops during high heat flux flow boiling of low-GWP refrigerants in 200 μm-wide multi-microchannels

被引:3
作者
Criscuolo, Gennaro [1 ]
Colombo, Luigi Pietro Maria [2 ]
Kanbur, Baris Burak [1 ]
Markussen, Wiebke Brix [1 ]
Kaern, Martin Ryhl [1 ]
机构
[1] Tech Univ Denmark, Dept Mech Engn, DK-2800 Kongens Lyngby, Denmark
[2] DOE, Politecn Milano, I-20156 Milan, Italy
关键词
High heat flux; Low GWP; Pressure drops; Flow boiling; Microchannel; Thermal management; R1234yf; R1234ze(E); 2-PHASE FLOW; TRANSFER COEFFICIENT; GENERAL CORRELATION; FUNDAMENTAL ISSUES; UNIVERSAL APPROACH; R1234YF; R134A; VISUALIZATION; R1234ZE(E); FRICTION;
D O I
10.1016/j.ijheatmasstransfer.2023.124882
中图分类号
O414.1 [热力学];
学科分类号
摘要
Thermal management of electronics is continuously challenged by increasing heat fluxes to be dissipated at minimum power consumption. This study investigated the pressure drops and the heat transfer coefflcient of two low-GWP refrigerants, R1234yf and R1234ze(E), during flow boiling at high heat fluxes. The test geometry comprised 25 parallel microchannels, 200 mu m wide, 1200 mu m deep and 1 cm long, nominally. Inlet orifices were used to stabilize the flow. A parametric analysis involving the mass flux and heat flux was conducted for nominal saturation temperatures of 30.5 degrees C and 40.5 degrees C, resulting in a maximum confinement number NConf of 2.16 for R1234yf and 2.52 for R1234ze(E). As the applied heat flux was increased from low to near-critical values, the two-phase heat transfer transitioned from a heat-flux-dominated mode to a convection-dominated one. The flow finally approached dryout, which led to the critical heat flux upon further heating. The experimental results were analysed through a regression with relevant non-dimensional groups, in particular the confinement number, NConf, the equivalent wall Biot number, Bi, the boiling number, Bo, the convection number, Co, and the Weber number, We. It was shown that Bo and Bi had a major influence in the heat-flux-dominated region, while Co and NConf determined the performance in the convective region, mainly due to the establishment of an intermittent annular flow. The total channel pressure drops were evaluated through the experimental measurement of the pressure drops in the inlet-outlet manifold, and the orifices. Due to the short channel length and the high heat fluxes, the pressure drops were dominated by the momentum change contribution, which accounted for at least 60% of the total pressure drops in the lowest case. The flow-wise heat transfer coefflcients and the channel pressure drops were compared with the predictions of existing correlations, showing generally a fair agreement.
引用
收藏
页数:17
相关论文
共 68 条
  • [11] PRESSURE-GRADIENTS DUE TO FRICTION DURING FLOW OF EVAPORATING 2-PHASE MIXTURES IN SMOOTH TUBES AND CHANNELS
    CHISHOLM, D
    [J]. INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 1973, 16 (02) : 347 - 358
  • [12] Comparison of heat transfer coefficient during evaporation of natural refrigerants and R-1234yf in horizontal small tube
    Choi, Kwang-Il
    Oh, Jong-Taek
    Saito, Kiyoshi
    Jeong, Jong Soo
    [J]. INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2014, 41 : 210 - 218
  • [13] Cooper M.G., 1984, Advances in Heat Transfer, V16, P157, DOI 10.1016/S0065-2717(08)70205-3
  • [14] High heat flux flow boiling of R1234yf, R1234ze(E) and R134a in high aspect ratio microchannels
    Criscuolo, Gennaro
    Markussen, Wiebke Brix
    Meyer, Knud Erik
    Kaern, Martin Ryhl
    [J]. INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2022, 186
  • [15] Experimental Characterization of the Heat Transfer in Multi-Microchannel Heat Sinks for Two-Phase Cooling of Power Electronics
    Criscuolo, Gennaro
    Markussen, Wiebke Brix
    Meyer, Knud Erik
    Palm, Bjorn
    Kaern, Martin Ryhl
    [J]. FLUIDS, 2021, 6 (02)
  • [16] Pressure drop during flow boiling inside parallel microchannels
    Dario, Evandro R.
    Passos, Julio C.
    Sanchez Simon, Maria L.
    Tadrist, Lounes
    [J]. INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2016, 72 : 111 - 123
  • [17] Flow boiling of R1234yf in a 1 mm diameter channel
    Del Col, Davide
    Bortolin, Stefano
    Torresin, Daniele
    Cavallini, Alberto
    [J]. INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2013, 36 (02): : 353 - 362
  • [18] Dittus FW, 1985, Int Commun Heat Mass Tran, V12, P3, DOI [10.1016/0735-1933(85)90003-X, DOI 10.1016/0735-1933(85)90003-X]
  • [19] Flow Boiling Heat Transfer and Pressure Drops of R1234ze(E) in a Silicon Micro-pin Fin Evaporator
    Falsetti, C.
    Magnini, M.
    Thome, J. R.
    [J]. JOURNAL OF ELECTRONIC PACKAGING, 2017, 139 (03)
  • [20] Experimental investigation on flow boiling characteristics of R1233zd(E) in a parallel mini-channel heat sink for the application in battery thermal management
    Fang, Yidong
    Yang, Wenliang
    Xu, Dan
    Hu, Lingren
    Su, Lin
    Huang, Yuqi
    [J]. INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2021, 178