Historical review and future prospect for researches on very high cycle fatigue of metallic materials

被引:18
|
作者
Sakai, Tatsuo [1 ,2 ]
机构
[1] Ritsumeikan Univ, Res Org Sci & Technol, Kusatsu, Japan
[2] Ritsumeikan Univ, Res Org Sci & Technol, 525 8577 Japan, 1-1-1 Nojihigashi, Kusatsu, Shiga 5258577, Japan
关键词
crack initiation mechanism; duplex S-N characteristics; future prospect; historical review; metallic materials; very high cycle fatigue; SUBSURFACE CRACK INITIATION; ROLLING-CONTACT FATIGUE; COMPETING FAILURE MODES; HIGH-STRENGTH STEELS; CR-NI-STEELS; BEARING STEEL; VHCF REGIME; PROPAGATION PROPERTIES; DEFORMATION-BEHAVIOR; FRACTURE-MECHANICS;
D O I
10.1111/ffe.13885
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
Since the first paper on the fatigue of metallic materials by J. Albert in 1837, tremendous numbers of papers have been published in various journals by many researchers all over the world. Based on such a long history, several papers on the very high cycle fatigue (VHCF) in the life-time longer than 10(7) cycles had appeared in some journals during the period of 1980's. One characteristic finding in these works is the fact that the metallic material can fail even at the stress level lower than the conventional fatigue limit. This fact means that the conventional fatigue design of mechanical structures cannot give the safety of the practical products in the very high cycle regime. Due to this fact, fatigue properties of structural materials in very long life regime has become an important subject; and a lot of studies have been carried out, and many important results have been accumulated until now. Typical aspects on VHCF property are summarized as follows: (1) the fatigue crack tends to occur around the interior inclusion, (2) fine granular area (FGA) is formed around such an inclusion, and (3) duplex S-N characteristics appear in the VHCF regime. In this paper, a brief historical review together with the future prospect on the very high cycle fatigue of metallic materials is attempted for the sake of reference to facilitate the research in this area.
引用
收藏
页码:1217 / 1255
页数:39
相关论文
共 50 条
  • [31] MICROSTRUCTURE AND FATIGUE BEHAVIOUR IN THE VERY HIGH CYCLE FATIGUE REGIME
    Zimmermann, M.
    Stoecker, C.
    Christ, H. -J.
    FATIGUE OF MATERIALS: ADVANCES AND EMERGENCES IN UNDERSTANDING, 2010, : 299 - 315
  • [32] Very-high-cycle fatigue behavior of a structural steel with and without induced surface defects
    Jiang, Qingqing
    Sun, Chengqi
    Liu, Xiaolong
    Hong, Youshi
    INTERNATIONAL JOURNAL OF FATIGUE, 2016, 93 : 352 - 362
  • [33] Mechanism of artificial surface defect induced cracking for very high cycle fatigue of Ti alloys
    Sun, Jian
    Peng, Wenjie
    Sun, Chengqi
    ENGINEERING FRACTURE MECHANICS, 2022, 272
  • [34] Very high cycle fatigue - Is there a fatigue limit?
    Pyttel, B.
    Schwerdt, D.
    Berger, C.
    INTERNATIONAL JOURNAL OF FATIGUE, 2011, 33 (01) : 49 - 58
  • [35] A novel evaluation method for high cycle and very high cycle fatigue strength
    Wu, Han
    Sun, Chengqi
    Xu, Wei
    Chen, Xin
    Wu, Xiaolei
    ENGINEERING FRACTURE MECHANICS, 2023, 290
  • [36] Very high cycle fatigue of bearing steels with artificial defects in vacuum
    Spriestersbach, D.
    Brodyanski, A.
    Loesch, J.
    Kopnarski, M.
    Kerscher, E.
    MATERIALS SCIENCE AND TECHNOLOGY, 2016, 32 (11) : 1111 - 1118
  • [37] Threshold values for very high cycle fatigue failure of high-strength steels
    Spriestersbach, D.
    Grad, P.
    Kerscher, E.
    FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES, 2017, 40 (11) : 1708 - 1717
  • [38] High-cycle and very high-cycle bending fatigue strength of shot peened spring steel
    Myung, NohJun
    Wang, Liang
    Choi, Nak-Sam
    JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY, 2021, 35 (11) : 4963 - 4973
  • [39] A microplasticity evaluation method in very high cycle fatigue
    Wang, X. G.
    Feng, E. S.
    Jiang, C.
    INTERNATIONAL JOURNAL OF FATIGUE, 2017, 94 : 6 - 15
  • [40] Influence of elevated temperature on the very high cycle fatigue properties of bearing steels
    Schoenbauer, Bernd M.
    More, Suraj S.
    Morales-Espejel, Guillermo E.
    Mayer, Herwig
    INTERNATIONAL JOURNAL OF FATIGUE, 2023, 176