A Computationally Efficient Method to Determine the Probability of Rainfall-Triggered Cut Slope Failure Accounting for Upslope Hydrological Conditions

We present a new computationally efficient methodology to estimate the probability of rainfall-induced slope failure based on mechanical probabilistic slope stability analyses coupled with a hydrogeological model of the upslope area. The model accounts for: (1) uncertainty of geotechnical and hydrogeological parameters; (2) rainfall precipitation recorded over a period of time; and (3) the effect of upslope topography. The methodology provides two key outputs: (1) time-varying conditional probability of slope failure; and (2) an estimate of the absolute frequency of slope failure over any time period of interest. The methodology consists of the following steps: first, characterising the uncertainty of the slope geomaterial strength parameters; second, performing limit equilibrium method stability analyses for the realisations of the geomaterial strength parameters required to calculate the slope probability of failure by a Monte Carlo Simulation. The stability analyses are performed for various phreatic surface heights. These phreatic surfaces are then matched to a phreatic surface time series obtained from the 1D Hillslope-Storage Boussinesq model run for the upslope area to generate Factor of Safety (FoS) time series. A time-varying conditional probability of failure and an absolute frequency of slope failure can then be estimated from these FoS time series. We demonstrate this methodology on a road slope cutting in Nepal where geotechnical tests are not readily conducted. We believe this methodology improves the reliability of slope safety estimates where site investigation is not possible. Also, the methodology enables practitioners to avoid making unrealistic assumptions on the hydrological input. Finally, we find that the time-varying failure probability shows marked variations over time as a result of the monsoon wet-dry weather. Probabilistic slope stability analyses are coupled with a hydrogeological hillslope model to estimate the probability and frequency of rainfall-induced slope failure.The model accounts for the uncertainty about rainfall using a time-dependent method, and for uncertainty relative to the geomaterial properties.The model is tested on a road cut slope in Nepal (mountainous area subject to a monsoon season) finding that the cut slope will fail every other year.Time-varying failure probability shows marked variations over time as a result of the monsoon wet-dry weather.The findings indicate that it is important to use a time-dependent system to represent rainfall variability for slope failure probability analysis.