Experimental study of peripheral fuel injection for higher performance in diesel engines

In conventional diesel combustion (CDC), a centrally located multi-hole injector supplies fuel radially outwards. This study introduces and explores the concept of peripheral fuel injection (PeFI) to supply fuel from multiple locations on top of the combustion chamber using several single-hole injectors. The PeFI concept is designed to eliminate flame-wall and jet-wall interactions, and, ideally, to produce independent flames without any interference. PeFI is also intended to increase air entrainment in the near field and thus, reduce equivalence ratio at the lift-off length and subsequent soot formation. PeFI reduces wall heat transfer compared to CDC although this feature is not considered in the present study. The two methods of fuel injection are compared in a non-reacting optical chamber via high-speed imaging of the jets. N-heptane fuel at 1500 bar supply pressures is injected into a test chamber filled with nitrogen at engine relevant ambient densities of 23.0 and 18.5 kg/m3. Four configurations are trialed including a six-hole central injector and six, single-hole PeFI injectors with holes oriented at a layout angle, defined as the angle between the center of the fuel jet and chamber radius, of 0 degrees, 15 degrees, and 30 degrees. Flow visualizations show jet-to-jet interactions at small layout angles for PeFI, but little to no jet-to-jet (or jet-wall) interference as the layout angle increases to 30 degrees. Image analysis reveals that PeFI provides faster rate of injection, longer jet penetration length, greater width near the jet tip, and larger jet volume compared to those for the central injector. Overall, results demonstrate the potential of PeFI to simultaneously improve fuel efficiency and reduce emissions in diesel engines.