Experimental evaluation of the durability of glass Textile-Reinforced concrete

被引:15
作者
Paul, Sachin [1 ]
Gettu, Ravindra [1 ]
Arnepalli, Dali Naidu [1 ]
Samanthula, Ramakrishna [1 ]
机构
[1] Indian Inst Technol, Madras, India
关键词
Textile reinforced concrete; AR glass; E-glass textiles; Alkaline exposure; Accelerated aging; Natural aging; Durability; FIBERS; CEMENT; PERFORMANCE; DEGRADATION; MECHANISMS; STRENGTH; BEHAVIOR; MATRIX; MODEL; BARS;
D O I
10.1016/j.conbuildmat.2023.133390
中图分类号
TU [建筑科学];
学科分类号
0813 ;
摘要
Textile reinforced concrete (TRC) is a promising alternative to conventional steel-reinforced systems, especially for slender, lightweight structural and nonstructural applications. One of the critical parameters to be accounted for in the design of these composites is their long-term mechanical performance, especially the reduction in tensile capacity with time. This paper looks at the influence of aging on the response of textiles and composites with AR- and E-glass fibers. Six coated glass textiles were exposed to three alkaline solutions with different pH ranges. Accelerated aging of the composites with these textiles was carried out with the hot water immersion method at 50 degrees C, and the reductions in tensile strength are compared with the results from the natural aging of composites over 4 years. Two matrices were used in the studies to identify the improvements due to lower water/ binder ratio and matrix porosity. The change in the morphology of fibers and coating after exposure is discussed with observations from scanning electron microscopy (SEM). The type and extent of textile coating have a profound influence on the residual strength of the composite. The composites with higher strength matrix showed better retention of strength. The trend of degradation in alkaline exposure, accelerated and natural aging is discussed with the comparison of the deterioration mechanism observed from microstructural studies in each case.
引用
收藏
页数:14
相关论文
共 43 条
[1]  
Alexander M., 2018, Research Monograph No.4, V2018, P29
[2]   Tensile properties degradation of glass fiber-reinforced polymer bars embedded in concrete under severe laboratory and field environmental conditions [J].
Almusallam, Tarek H. ;
Al-Salloum, Yousef A. ;
Alsayed, Saleh H. ;
El-Gamal, Sherif ;
Aqel, Mohammed .
JOURNAL OF COMPOSITE MATERIALS, 2013, 47 (04) :393-407
[3]  
[Anonymous], 2000, ETAG 004
[4]  
[Anonymous], 2015, ASTM D6637
[5]   Effect of microsilica and acrylic: Polymer treatment on the ageing of GRC [J].
Bartos, PJM ;
Zhu, WZ .
CEMENT & CONCRETE COMPOSITES, 1996, 18 (01) :31-39
[6]   Effect of Different Constituent Fiber, Resin, and Sizing Combinations on Alkaline Resistance of Basalt, Carbon, and Glass FRP Bars [J].
Benmokrane, B. ;
Hassan, M. ;
Robert, M. ;
Vijay, P. V. ;
Manalo, A. .
JOURNAL OF COMPOSITES FOR CONSTRUCTION, 2020, 24 (03)
[7]  
Benmokrane B, 2018, J BRIDGE ENG, V23, DOI [10.1061/(ASCE)BE.1943-5592.0001315, 10.1061/(ASCE)BE.1943-5592.01315]
[8]   Laboratory assessment and durability performance of vinyl-ester, polyester, and epoxy glass-FRP bars for concrete structures [J].
Benmokrane, Brahim ;
Ali, Ahmed H. ;
Mohamed, Hamdy M. ;
ElSafty, Adel ;
Manalo, Allan .
COMPOSITES PART B-ENGINEERING, 2017, 114 :163-174
[9]   Role of interfaces in controlling durability of fiber-reinforced cements [J].
Bentur, A .
JOURNAL OF MATERIALS IN CIVIL ENGINEERING, 2000, 12 (01) :2-7
[10]  
Bentur A, 2006, Fibre reinforced cementitious composites