High-ductility fine-grained Mg-1.92Zn-0.34Y alloy fabricated by semisolid and then hot extrusion

The combination of semisolid and hot extrusion processing was applied to refine the icosahedral quasicrystalline phase (I-phase) in an extruded Mg-1.92Zn-0.34Y(wt.%) alloy for the first time. The semisolid isothermal heat treatment transformed the micron-sized I-phase particles into nano lamellar eutectic (alpha-Mg + I-phase) with a lamellar spacing of similar to 86 nm. After subsequent hot extrusion at 250 degrees C, the nano lamellar eutectic phases were broken into uniformly dispersed nanoscale I-phase particles. What's more, the matrix microstructure was significantly refined with an equiaxed average grain size of 2.59 +/- 0.81 mu m, and an unusual texture component (most of the grains' c-axis is parallel to the extrusion direction) was observed. The processed alloy exhibited a high tensile elongation to failure (EL) of 44 +/- 2.6% with an ultimate tensile strength (UTS) of 258 +/- 2.0 MPa and a tensile yield strength (TYS) of 176 +/- 1.6 MPa at room temperature. The high ductility from the combined effects of the grain refinement, dispersion of nanoscale I-phase particles, and the unusual texture. The uniform dispersion of nanoscale I-phase particles could promote grain refinement by particle stimulated nucleation mechanism, and thus bring the unusual texture (where the c-axis is aligned parallel to the extrusion direction during dynamic recrystallization, which contributed to ductility).(c) 2021 Chongqing University. Publishing services provided by Elsevier B.V. on behalf of KeAi Communications Co. Ltd. This is an open access article under the CC BY-NC-ND license ( http://creativecommons.org/licenses/by-nc-nd/4.0/ ) Peer review under responsibility of Chongqing University