Superplasticity of fine-grained Mg-10Li alloy prepared by severe plastic deformation and understanding its deformation mechanisms

被引:5
作者
Jeong, H. T. [1 ]
Lee, S. W. [1 ]
Kim, W. J. [1 ]
机构
[1] Hongik Univ, Dept Mat Sci & Engn, Sangsu Dong 72-1, Seoul 121791, South Korea
关键词
Magnesium-lithium alloy; Superplasticity; Severe plastic deformation; Grain size; Grain growth; LOW-TEMPERATURE SUPERPLASTICITY; MG-LI ALLOYS; ELEVATED-TEMPERATURE; PHASE-TRANSFORMATION; AL; BEHAVIOR; MAPS; MICROSTRUCTURE; DIFFUSION; CREEP;
D O I
10.1016/j.jma.2024.01.001
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
The superplastic behavior and associated deformation mechanisms of a fine-grained Mg -10.1 Li-0.8Al-0.6Zn alloy (LAZ1011) with a grain size of 3.2 mu m, primarily composed of the BCC )5 phase and a small amount of the HCP alpha phase, were examined in a temperature range of 473 K to 623 K. The microstructural refinement of this alloy was achieved by employing high -ratio differential speed rolling. The best superplasticity was achieved at 523 K and at strain rates of 10-4 -5 x 10-4 s-1, where tensile elongations of 550-600% were obtained. During the heating and holding stage of the tensile samples prior to tensile loading, a significant increase in grain size was observed at temperatures above 573 K. Therefore, it was important to consider this effect when analyzing and understanding the superplastic deformation behavior and mechanisms. In the investigated strain rate range, the superplastic flow at low strain rates was governed by lattice diffusion-controlled grain boundary sliding, while at high strain rates, lattice diffusion-controlled dislocation climb creep was the rate-controlling deformation mechanism. It was concluded that solute drag creep is unlikely to occur. During the late stages of deformation at 523 K, it was observed that grain boundary sliding led to the agglomeration of the alpha phase, resulting in significant strain hardening. Deformation mechanism maps were constructed for )5 -Mg -Li alloys in the form of 2D and 3D formats as a function of strain rate, stress, temperature, and grain size, using the constitutive equations for various deformation mechanisms derived based on the data of the current tests. (c) 2024 Chongqing University. Publishing services provided by Elsevier B.V. on behalf of KeAi Communications Co. Ltd. This is an open access article under the CC BY-NC-ND license ( http://creativecommons.org/licenses/by-nc-nd/4.0/ ) Peer review under responsibility of Chongqing University
引用
收藏
页码:316 / 331
页数:16
相关论文
共 50 条
  • [41] High strain rate superplasticity of submicrometer grained 5083 Al alloy containing scandium fabricated by severe plastic deformation
    Park, KT
    Hwang, DY
    Lee, YK
    Kim, YK
    Shin, DH
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2003, 341 (1-2): : 273 - 281
  • [42] Deformation mechanism of fine-grained superplasticity in metallic materials expected from the phenomenological constitutive equation
    Watanabe, H
    Mukai, T
    Higashi, K
    MATERIALS TRANSACTIONS, 2004, 45 (08) : 2497 - 2502
  • [43] Room Temperature Superplaticity in Fine/Ultrafine Grained Materials Subjected to Severe Plastic Deformation
    Demirtas, M.
    Purcek, G.
    MATERIALS TRANSACTIONS, 2019, 60 (07) : 1159 - 1167
  • [44] Influence of severe plastic deformation on dynamic strain aging of ultrafine grained Al-Mg alloys
    Zhao, Shiteng
    Meng, Chenlu
    Mao, Fengxin
    Hu, Weiping
    Gottstein, Guenter
    ACTA MATERIALIA, 2014, 76 : 54 - 67
  • [45] Impressive Effect of Li Microalloying and Severe Plastic Deformation of Al–Cu–Mg Alloy on Strength and Corrosion Resistance
    Hamed Jamshidi Aval
    Arabian Journal for Science and Engineering, 2023, 48 : 12485 - 12497
  • [46] Superplasticity in a fine-grained Mg-Zn-Y-Zr alloy containing quasicrystalline particles
    Kim, Y
    Bae, D
    MATERIALS TRANSACTIONS, 2004, 45 (12) : 3298 - 3303
  • [47] Evolution of Deformation Substructure and MgxZnyCaz Metastable Phase in Fine-Grained Mg Alloys
    Li, Zhen-Liang
    Zhang, Xin-Lei
    ACTA METALLURGICA SINICA-ENGLISH LETTERS, 2025, 38 (01) : 71 - 85
  • [48] Electrochemical corrosion behavior of ultrafine-grained Mg alloy ZE41A through severe plastic deformation
    Shen, Zhixin
    Ma, Aibin
    Jiang, Jinghua
    Song, Dan
    Lu, Fumin
    2011 CHINESE MATERIALS CONFERENCE, 2012, 27 : 1817 - 1822
  • [49] Deformation mechanisms in a fine-grained Udimet 720LI nickel-base superalloy with high volume fractions of γ' phases
    Chen, Jiayu
    Dong, Jianxin
    Zhang, Maicang
    Yao, Zhihao
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2016, 673 : 122 - 134
  • [50] Mechanical properties and deformation mechanisms of a novel fine-grained Mg-Gd-Y-Ag-Zr-Ce alloy with high strength-ductility synergy
    Cui, Xiaofei
    Fu, Wei
    Fang, Daqing
    Bi, Guangli
    Ren, Zijun
    Guo, Shengwu
    Li, Suzhi
    Ding, Xiangdong
    Sun, Jun
    JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY, 2021, 66 : 64 - 73