Novel method to achieve synergetic strength-ductility improvement of Al-Cu alloy by in situ TiC-TiB2 particles via direct reaction synthesis

Insufficient performance, especially at high temperatures, limits the extensive application of cast Al-Cu alloys. This study proposes a novel method of direct reaction synthesis (DRS) for the simultaneous synthesis and dispersion of hybrid-sized in situ TiC-TiB2 particles in the melt to prepare a trace-particle-reinforced high-performance cast Al-Cu5.5-Mn0.45-Ti0.3-V0.3-Cr0.2-Zr0.14-B0.04 alloy. The particulate-reinforced alloy achieved strength-ductility synergetic enhancement at room and high temperatures. In comparison to the Al-Cu matrix alloy, the yield strength of 0.7 wt% (TiC-TiB2)/Al-Cu alloy at 298 K (529 MPa), 493 K (214 MPa), and 533 K (183 MPa) had an increase of 28%, 18% and 35%, meanwhile their elongation increased by 4%, 50% and 62%, respectively. The yield strength enhancement primarily benefited from the thermal mismatch between the particles and matrix, and Orowan strengthening. The strength-ductility performance improvement is due to the optimization of the microstructure: significantly refined & alpha;-Al grains with smaller and more dispersed & theta;MODIFIER LETTER PRIME precipitates. Further, the improvement mechanism of the microstructure is due to the action of the nanoparticles on the heterogeneous nucleation stimulation and dendrite growth inhibition of & alpha;-Al during the solidification process. Meanwhile, the segregation of the Cu atoms was inhibited by the particles. The precipitation was significantly promoted because of more uniformly distributed Cu atoms, and more defects induced by particles improved diffusion of the Cu atoms the number and density of the precipitation sites. The results of this study provide an economical and accessible synthesis strategy for industrial manufacturing.