Piezoelectric sensing method for segmental joint contact stress during shield tunnel construction

The emergence of curved shield tunnels poses a significant construction challenge. If the quality of the segment assembly is not guaranteed, many segment cracks and damage will result from the stress concentration. Sensing the contact stresses between segmental joints is necessary to improve the quality of segments assembled for shield tunnel construction. Polyvinylidene difluoride (PVDF) piezoelectric material was chosen for the sensor because it can convert contact stresses into electrical signals, allowing the state of the segmental joints to be effectively sensed. It matches the working environment between the segmental joints of the shield tunnel, where flexible structures such as rubber gaskets and force transfer pads are present. This study proposes a piezoelectric sensing method for segmental joints in shield tunnels and conducts laboratory tests, numerical analyses, and field tests to validate the feasibility of the method. The results indicate that the PVDF film sensor can effectively sense the entire compression process of the gasket with different amounts of compression. The piezoelectric cable sensor can effectively sense the joint offset direction of the gasket. For differently shaped sections, the variation in the force sensed by the piezoelectric cable sensors was different, as verified by numerical simulation. Through the field test, it was found that the average contact stress between the segmental joints was in the range of 1.2-1.8 MPa during construction of the curved shield tunnels. The location of the segmental joints and the type of segment affect the contact stress value. The field monitoring results show that piezoelectric sensing technology can be successfully applied during assembly of the segments for effective sensing of the contact stress.