Effect of graphene nano-particle reinforcement on the fatigue behavior of adhesively bonded single lap joints

被引：23

作者：

Bali, Guntac ^{[1
]}

Topkaya, Tolga ^{[1
]}

机构：

[1] Batman Univ, Engn & Architecture Fac, Mech Engn Dept, TR-72100 Batman, Turkiye

来源：

INTERNATIONAL JOURNAL OF ADHESION AND ADHESIVES | 2023年 / 120卷

关键词：

Graphene; Single lap joint; Fatigue; Energy dissipation; Stiffness reduction; MECHANICAL-PROPERTIES; CARBON NANOTUBE; EPOXY ADHESIVE; NANOCOMPOSITE; STRENGTH; OXIDE; NANOSTRUCTURE; COMPOSITES; NANOPLATELETS; LIFE;

D O I：

10.1016/j.ijadhadh.2022.103279

中图分类号：

TQ [化学工业];

学科分类号：

0817 ;

摘要：

Present study aims to investigate tensile fatigue behavior of adhesive single lap joints with a graphene nano -particle modified adhesive (GNP). Carbon fiber reinforced plastic and 3 M DP460 was used as adherend and adhesive, respectively. In addition to the unreinforced adhesive, wt. 0.25%, wt. 0.5% and wt. 1% GNP reinforced adhesives were used. Tensile test results showed that increasing the GNP ratio increased the tensile strength of joints. The interior regions of the overlap region exhibited cohesive substrate failure and fiber tear failure, while the ends of the overlap region exhibited adhesive and cohesive failure. 0.5% GNP reinforced adhesive joints showed the highest fatigue life. Cohesive failure and adhesive failure were the main failure types for lower load levels. Increasing the fatigue load level caused different damage types to occur. The stiffness reduction didn't happen until the very end of the fatigue tests.

引用

页数：8

共 44 条

[1]

Adin H., 2021, Eur Mech Sci, V5, P168

[2] Effects of particle reinforcement on the bending and compressive behaviors of composite pipes [J].

Adin, Hamit .

MATERIALS TESTING, 2019, 61 (11) :1072-1076

[3] Investigation of mechanical and thermal properties of nanostructure-doped bulk nanocomposite adhesives [J].

Akpinar, Iclal Avinc ;

Gurses, Ahmet ;

Akpinar, Salih ;

Gultekin, Kursat ;

Akbulut, Hamit ;

Ozel, Adnan .

JOURNAL OF ADHESION, 2018, 94 (11) :847-866

[4] Experimental analysis on the single -lap joints bonded by a nanocomposite adhesives which obtained by adding nanostructures [J].

Akpinar, Idal Avinc ;

Gultekin, Kursat ;

Akpinar, Salih ;

Akbulut, Hamit ;

Ozel, Adnan .

COMPOSITES PART B-ENGINEERING, 2017, 110 :420-428

[5] The fracture load analysis of different material thickness in adhesively bonded joints subjected to fully reversed bending fatigue load [J].

Akpinar, Salih ;

Sahin, Resul .

THEORETICAL AND APPLIED FRACTURE MECHANICS, 2021, 114

[6] Effect of nanostructured reinforcement of adhesive on thermal cycling performance of a single-lap joint with composite adherends [J].

Akpinar, Salih ;

Akpinar, Iclal Avinc .

COMPOSITES PART B-ENGINEERING, 2019, 175

[7] Experimental and numerical determination of the thermal cycle performance of joints obtained with nanostructure-doped nanocomposite adhesives [J].

Akpinar, Salih ;

Ozel, Adnan .

COMPOSITES PART B-ENGINEERING, 2019, 174

[8] Fatigue in sisal fiber reinforced polyester composites: hysteresis and energy dissipation [J].

Belaadi, A. ;

Bezazi, A. ;

Maache, M. ;

Scarpa, F. .

XVII INTERNATIONAL COLLOQUIUM ON MECHANICAL FATIGUE OF METALS (ICMFM17), 2014, 74 :325-328

[9] Carbon nanotube - Carbon fiber reinforced polymer composites with extended fatigue life [J].

Boroujeni, Ayoub Yari ;

Al-Haik, Marwan .

COMPOSITES PART B-ENGINEERING, 2019, 164 :537-545

[10] Fatigue behavior of short carbon fiber reinforced epoxy composites [J].

Capela, C. ;

Oliveira, S. E. ;

Ferreira, J. A. M. .

COMPOSITES PART B-ENGINEERING, 2019, 164 :191-197

← 1 2 3 4 5 →