Study of the surface roughness and optimization of machining parameters during laser-assisted fast tool servo machining of glass-ceramic

Glass-ceramic is a typical hard and brittle material that is difficult to machine. In order to improve the surface quality of laser-assisted fast tool servo machining optical free-form surface of glass-ceramic, the effects of spindle speed, feed speed, piezoelectric frequency and laser power on the surface roughness were investigated. Firstly, the Taguchi method (TM) was used to establish the orthogonal experiment, and the contribution rate of each machining parameter to the surface roughness was obtained through variance and signal-to-noise ratio (S/N) analysis. The order of the influence degree of each parameter on the surface roughness is as follows: laser power > spindle speed > feed speed > piezoelectric frequency. The optimal machining parameter combinations obtained for the TM experiment are as follows: spindle speed 50 rpm, feed speed 0.01 mm rev(-1), piezoelectric frequency 8 Hz, laser power 75 W. The range of surface roughness reduction obtained by comparing laser-assisted machining (LAM) with pure fast tool servo (FTS) machining is 38.75%similar to 58.77%. The Box-Behnken Design (BBD) in response surface methodology (RSM) was used to design experiments and a regression model for surface roughness was established through RSM. The deviation between the surface roughness predicted by the regression equation and the experimental value is less than +/- 6%. The influence law of various machining parameters on surface roughness was studied through three-dimensional response surface. RSM optimized the minimum surface roughness with a desirability of 99.43%. The optimal combination of machining parameters optimized through RSM is as follows: spindle speed 53.71 rpm, feed speed 0.02 mm rev(-1), piezoelectric frequency 6.73 Hz, laser power 72 W. This paper is the first to combine LAM with FTS for machining optical free-form surface of glass-ceramic. This study provides a reference for laser-assisted fast tool servo machining and the research methods of surface quality.