Hydrofracturing fluid-weakened shear behavior of sandstone joints

被引:1
|
作者
Song, Jinliang [1 ,2 ]
Cheng, Dongliang [1 ]
Jiang, Annan [1 ]
Hu, Dawei [2 ]
Ma, Jun [1 ]
Ding, Changdong [3 ]
机构
[1] Dalian Maritime Univ, Coll Transportat Engn, Dalian 116026, Liaoning, Peoples R China
[2] Chinese Acad Sci, Inst Rock & Soil Mech, State Key Lab Geomech & Geotech Engn, Wuhan 430071, Hubei, Peoples R China
[3] Changjiang River Sci Res Inst, Key Lab Geotech Mech & Engn, Minist Water Resources, Wuhan 430010, Hubei, Peoples R China
基金
中国国家自然科学基金;
关键词
Hydrofracturing fluid treatment; Hydrofracturing fluid-weakened mechanism; Joint fabrication; Shear behavior; Sandstone joint; MECHANICAL-PROPERTIES; ELASTIC-MODULUS; ROCK; INDENTATION; STRENGTH; MODEL; SHALE; LOAD;
D O I
10.1007/s11440-023-02141-7
中图分类号
P5 [地质学];
学科分类号
0709 ; 081803 ;
摘要
The weakened shear behavior of sandstones induced by hydrofracturing fluids significantly affects the activation of natural fractures during hydraulic stimulation in hydrocarbon and geothermal exploitations. This paper presents an experimental study of characterizing the sandstone joints treated by water-based fracturing fluid (WFF) and acid mixture solution (AMS) treatment that simulate rock joint-hydrofracturing fluid interactions in deep reservoirs during short shut-off times on wells after hydraulic fracturing. Three-dimensional (3D) optical scanning method coupled with 3D rigid engraving was utilized to create replicas of natural rock joint surfaces, and direct shear tests were conducted to probe the shearing behavior of untreated and WFF/AMS-treated replicas with three different roughness levels and under two high normal stresses of 15 and 30 MPa. Microindentation and X-ray diffraction were then performed to investigate the degradation of mechanical properties and potential alterations in composition and microstructure of the hydrofracturing fluid-treated joint surfaces. The results indicate that short-term interactions between the hydrofracturing fluids and sandstone can lead to a reduction in mechanical properties and frictional resistance of the joint surface, ultimately weakening its shearing properties. The decline in mechanical properties observed in the AMS-treated sample is attributed predominantly to the dissolution of QFC (quartz, feldspar, and calcite) and swelling of clay minerals. For the WFF-treated sample, clay mineral swelling and the residual guanidine gum on the joint surfaces remain the primary factors contributing to the reduction in shearing resistance. At high normal stresses of 15 and 30 MPa, joints with different roughnesses exhibit asperity shearing off as the dominant mechanism. Furthermore, an increase in joint roughness leads to a higher friction angle on the joint surface. However, higher normal loads could result in a reduction in apparent cohesion. The results of this study provide valuable insights into the interactions between hydrofracturing fluids and sandstone, as well as the behavior of natural fracture activation during hydraulic fracturing.
引用
收藏
页码:4367 / 4379
页数:13
相关论文
共 50 条
  • [21] Cross-scales Analysis Of Shear Behavior In Fontainebleau Sandstone
    Nguyen, Trung-Kien
    Vo, Thanh-Trung
    JOURNAL OF APPLIED SCIENCE AND ENGINEERING, 2025, 28 (03): : 441 - 449
  • [22] An empirical formula for peak shear strength of irregular sandstone joints under seepage flow
    Cheng T.
    Guo B.
    Sun J.
    Tian S.
    Chen Y.
    Yanshilixue Yu Gongcheng Xuebao/Chinese Journal of Rock Mechanics and Engineering, 2022, 41 (SUPPLEMENT 2): : 3141 - 3151
  • [23] SHEAR BEHAVIOR OF IRREGULAR TRIANGULAR ROCK CONCRETE JOINTS
    KODIKARA, JK
    JOHNSTON, IW
    INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES & GEOMECHANICS ABSTRACTS, 1994, 31 (04) : 313 - 322
  • [24] Experimental investigation on the cyclic shear behavior of intermittent joints
    Wang, Bin
    Jiang, Yujing
    Zhang, Qiangyong
    Chen, Hongbin
    Liu, Richeng
    INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES, 2024, 181
  • [25] The Influence of Shearing Velocity on Shear Behavior of Artificial Joints
    Atapour, Hadi
    Moosavi, Mahdi
    ROCK MECHANICS AND ROCK ENGINEERING, 2014, 47 (05) : 1745 - 1761
  • [26] SHEAR BEHAVIOR OF JOINTS IN PRECAST CONCRETE SEGMENTAL BRIDGES
    BUYUKOZTURK, O
    BAKHOUM, MM
    BEATTIE, SM
    JOURNAL OF STRUCTURAL ENGINEERING-ASCE, 1990, 116 (12): : 3380 - 3401
  • [27] The Influence of Shearing Velocity on Shear Behavior of Artificial Joints
    Hadi Atapour
    Mahdi Moosavi
    Rock Mechanics and Rock Engineering, 2014, 47 : 1745 - 1761
  • [28] Empirical and mathematical formulation of the shear behavior of rock joints
    Usefzadeh, Arash
    Yousefzadeh, Hamed
    Salari-Rad, Hossein
    Sharifzadeh, Mostafa
    ENGINEERING GEOLOGY, 2013, 164 : 243 - 252
  • [29] Shear Behavior of Rough Rock Joints Reinforced by Bolts
    Chen, Na
    Zhang, Xiaobo
    Jiang, Qinghui
    Feng, Xixia
    Wei, Wei
    Yi, Bing
    INTERNATIONAL JOURNAL OF GEOMECHANICS, 2018, 18 (01)
  • [30] Shear behavior of horizontal joints between precast panels
    Pramodh R.
    Shripriyadharshini V.
    Vidjeapriya R.
    Asian Journal of Civil Engineering, 2018, 19 (6) : 651 - 662