Research on microstructure and mechanical properties of TC4/304 clad plates by asymmetric rolling with local strong stress

In order to solve the problems of complex traditional preparation process and low bonding strength of titanium/ steel clad plates, TC4/304 clad plates were prepared by asymmetric rolling with local strong stress (ARLSS), the effect of rolling temperature on the interface bonding of clad plates was studied. The two-dimensional simulation model of TC4/304 clad plates rolling was established by finite element method, and its accuracy was verified by experiments. The experimental results show that the interfacial bonding strength of the clad plates increased with the increasing temperature, but when the temperature reached 950 degree celsius, the brittle intermetallic compounds (IMCs) formed extremely fast, which greatly weakens the bonding strength. The clad plates showed the best bonding strength at 900 degree celsius. After corrugated roll bonding (CRB) (33 % reduction ratio), the bonding strength at the peak was lower than that at the trough. After FRB (46 % reduction ratio), the interface bonding strength was slightly improved. The final peak bonding strength reached 519 MPa, and the trough bonding strength was 527 MPa. The improvement of bonding strength mainly came from the improvement of TC4 matrix strength. The finite element simulation results showed that multiple cross shear zone in the deformation zone of the CRB stage were beneficial to the bonding of dissimilar metals. While the deformation of the clad plates material in the FRB stage was consistent, which effectively avoided the cracking of the bonded area and further improved the bonding strength. Therefore, the strong non-uniform plastic deformation of ARLSS process had a significant effect on the deformation coordination of dissimilar metals and the quality improvement of clad plates.